Panasonic WJ-HD716K ユーザーズマニュアル
81
Step 1
Select the desired day of the week.
→ The time table of the selected day of the week will be
displayed.
Step 2
Configure each setting item.
There are 2 setup pages. To move to another page, select
the [
There are 2 setup pages. To move to another page, select
the [
k] or [l] button.
[Copy the other program]
To copy a time table set for another day of the week, select
the day of the week to be copied, and select the [Copy] but-
ton.
To copy a time table set for another day of the week, select
the day of the week to be copied, and select the [Copy] but-
ton.
■
New time table setup
Configure the settings of the following item for each time
zone.
zone.
[Start]
Set the start time of the time zone.
Set the start time of the time zone.
[End]
Set the end time of the time zone.
Set the end time of the time zone.
Note:
• The time can be set in 1-minute increments.
However, the end time should be at least 15 minutes
However, the end time should be at least 15 minutes
later than the start time.
• It is impossible to set "23:46" or later for the start time.
• Set "Start" and "End" in the 24-hour time display format.
• Set "Start" and "End" in the 24-hour time display format.
[Program]
Select the desired program (PROG1 to 4).
Select the desired program (PROG1 to 4).
[Event]
Select "On" or "Off" to determine whether or not to perform
event actions at an event occurrence.
Select "On" or "Off" to determine whether or not to perform
event actions at an event occurrence.
[Alarm message]
Select "On" or "Off" to determine whether or not to display
the pop-up window that notify of an event occurrence with a
message on the screen of the PC.
Select "On" or "Off" to determine whether or not to display
the pop-up window that notify of an event occurrence with a
message on the screen of the PC.
[FTP image transmission by alarm]
Select "On" or "Off" to determine whether or not to transmit
the alarm image to the FTP server according to the settings
of "Image transmission by alarm" (+ page 96) on the
"Server" page - the [FTP] tab.
Select "On" or "Off" to determine whether or not to transmit
the alarm image to the FTP server according to the settings
of "Image transmission by alarm" (+ page 96) on the
"Server" page - the [FTP] tab.
Assign a program after setting the time zone [Time table]
Select the [Time table] tab on the "Schedule" page. (+ Page 60)
A time table for program actions can be created for each day of the week, and programs can be assigned to each time table. Up
to 6 time tables can be created for each day of the week.
When a signal is supplied from the ALARM/CONTROL connector (external recording changeover, pin no. 24), the recorder will
work with the set timetable for "Ext." regardless of the days of the week.
At the default, 0:00 to 24:00, PROG1 has been set for "Daily".
A time table for program actions can be created for each day of the week, and programs can be assigned to each time table. Up
to 6 time tables can be created for each day of the week.
When a signal is supplied from the ALARM/CONTROL connector (external recording changeover, pin no. 24), the recorder will
work with the set timetable for "Ext." regardless of the days of the week.
At the default, 0:00 to 24:00, PROG1 has been set for "Daily".