Panasonic WJ-HD716K ユーザーズマニュアル

88

Select the [Monitor 2] tab on the "Display" page. (+ Page 60)
Set the position to display the status bar and select "On" or "Off" to determine whether or not to display the camera title. 
The settings relating to the sequence display on Monitor 2 can also be configured on this tab. 
     

[Status display]
Select the position to display the status bar. 

Upper: Displays the status bar on the top of the screen. 
Low: Displays the status bar on the bottom of the 

screen. 

Default: Low:

[Camera title display]
Select "On" or "Off" to determine whether to enable or dis-
able the camera title display. 

[Login screen]
Select a camera image to be displayed during the login pro-
cedure. 
Available setting values are the same as Monitor 1. Refer to 
page 86. 

[Live sequence]
Configure the sequential display settings of camera images. 
The setup procedure is the same as Monitor 1. Refer to 
page 86. 
     

[Sequence timing]
Determine how to switch camera images. 

Int: Switches images according to the settings of the 

"Dwell time" of "Live sequence". 

Ext: Switches images by signals from an external 

device. 

 •  "Ext" is selected when an external device is connected

to output the sequence signals

 •  Pin No. 21 (Sequence Switching) of the ALARM/

CONTROL connector on the rear panel of the recorder 
works as an input terminal when "Int" is set for 
"Sequence timing", and works as an output terminal 
when "Ext" is set. 

 
     

Configure the sequential display settings of camera images. 
When selecting the [Setup] button of "Live Sequence" on the [Monitor 2] tab, the setup page for live sequence will be displayed. 
The setup procedure is the same as Monitor 1. Refer to page 87.