Panasonic CQ-5100U ユーザーズマニュアル

ページ / 32
CQ-5100U
19
Sound skips due to 
vibration.
Mounting angle is over 30˚.
a
Adjust mounting angle to less than 30˚.
Instable mounting.
a
Mount the unit securely with the mounting parts, referring to the
section on installation.
Much noise in FM stereo
and monaural broad-
casts.
Trouble
Station is too far, or signals are too weak.
a
Select other stations of higher signal level.
The radio antenna is not extended enough.
a
Extend fully the radio antenna.
Preset station is reset.
Battery cable is not correctly connected.
a
Connect the battery cable to the terminal that is always active.
Check point
❐ Radio
Disc is in the CD
compartment but no
sound is made, or disc is
ejected automatically.
Trouble
Disc is upside down.
a
Place disc in the correct direction with the label side up.
Sound skips, bad sound
quality. (e.g. caused by
noise)
• Disc is dirty.
• Disc has scratches.
a
Clean disc, referring to the section on “Notes on Discs”.
a
The unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.
• Disc is dirty.
• Disc has scratches.
a
Clean disc, referring to the section on “Notes on Discs”.
A disc that has data other than CD-DA type is loaded.
a
Discs that have CD-DA type data should be used.
a
The unit may not successfully playback a CD-R/RW that is made in
combination of writing software, a CD recorder (CD-R/RW drive) and a
disc which are incompatible one another. Refer to instructions for the
concerned devices for details.
Check point
❐ CD
CQ-5100U  10/8/2007  4:24 PM  頁面 19