Panasonic WJ-HD309A ユーザーズマニュアル

100

[Screenshot 5]
The motion detection area is set with the start point and the
end point as the points at opposite angles of the motion
detection area.

n Repeat steps 4 and 5 to set another motion detection

area.
Up to 4 areas can be set. The newly created areas will
be named automatically as A, B, C and D in the order of
creation.

m To complete the settings, rotate the jog dial to select

"EXIT" on the status bar, and press the SET button.

[Screenshot 6]
The "VMD Setup" window will be closed and the "VMD
Setup" pop-up menu will be displayed.

, Press the SETUP/ESC button.

→ The "VMD Setup" pop-up menu will be closed.

• Refer to page 115 for descriptions of how to delete

the motion detection area.

• It is possible to set the sensitivity and the detection

mode (method of detection) of each detection area.
Refer to page 115 for further information.

■ [Network]

Perform the settings for the network such as the IP address
and the gateway address when operating this unit a PC via
a network such as a LAN.

8 Line Speed

The following are available for "Line Speed".
AUTO: Line speed will be applied automatically.
10-HALF: 10 Mbps half duplex
10-FULL: 10 Mbps full duplex
100-HALF: 100 Mbps half duplex
100-FULL: 100 Mbps full duplex

Note: When the SETUP MENU is closed after changing the

line speed, the unit will automatically restart.

8 HTTP Port Number

Specify the HTTP port number to be used to transfer
images from this unit. It is not necessary to change it for
normal use.

8 DHCP

Select ON or OFF whether or not to use the DHCP server.
When obtaining IP addresses, net mask and a gateway
address from the DHCP server, set to ON.
If not, set to OFF and enter those addresses manually.
ON: Uses the DHCP server.
OFF: Does not use the DHCP server.

8 IP Address

Enter an IP address when OFF is selected for "DHCP".
For this unit, enter 4 units from the decimal numbers (0-
254).

8 Subnet Mask

Enter a subnet mask according to the network configuration
when OFF is selected for "DHCP".

8 Gateway

Enter the gateway address according to the network con-
figuration when OFF is selected for "DHCP".

■

■

■

■

■

■

■

■

■

■

■

■

■

■