Panasonic WJ-HD309A ユーザーズマニュアル

120

MAN. (MANUAL): The recording duration will be as follows

depending on the event type.

• At a motion detection: For 8 seconds
• At a video loss occurrence: During a video loss occur-

rence

• At a terminal alarm occurrence: During the supply of a

signal

• At a command alarm: For 8 seconds 

CON. (CONTINUE): Recording will be performed continu-

ously until the ALARM RESET button is pressed.

• When "MAN." is selected for the recording duration,

recording will be performed for 8 seconds at least at an
event occurrence as long as the alarm is not canceled.

• Available recording duration for pre-event recording will

differ depending on the settings of "Resolution" and
"Recording Rate and Quality" for pre-event recording as
below: 

• When the recording rate is low, images may be record-

ed for a longer duration than the set pre-event record-
ing duration.

• Pre-event recording will not be performed for a camera

channel whose post-event recording rate is OFF.

• Audio will be recorded up to for 16 seconds before the

event occurrence. However, audio will not be recorded
during pre-event recording that is being performed in
the HDD pre-recording area.

• In case that the pre-event recording is to be performed,

when two or more events occur continuously in a
moment, the start time of the post-event recording of
the second event and later will be delayed respectively.
(The actual time and date of the event occurrences will
be recorded on the event log.) In this case, the start
time of the pre-event recording will be delayed auto-
matically.
When performing the pre-event recording in an environ-
ment where two or more events may occur at short
times frequently, it is recommended to set the pre-
recording duration longer.

Important:
Pre-event recording image only just recorded will be delet-
ed in the following cases:

• When the SETUP MENU is closed after changing the

settings

• When post-event recording is newly performed
• When the time zone of a schedule switched and record-

ing had just started

• When the date has been changed

● [Event Program] Create event programs for

Perform the settings of event action for each event type
(motion detection, video loss, terminal/command alarm) or
of auto copy.

0.1

0.2

0.3

0.4

0.5

1

2

3

5

6

7.5

10

15

30

60

Recording
rate

5 min

2 min

1 min

1 min

1 min

30 s

10 s

10 s

7 s

6 s

4 s

3 s

2 s

1 s

-

10 min

5 min

3 min

2 min

2 min

1 min

30 s

20 s

10 s

10 s

9 s

7 s

4 s

2 s

1 s

20 min

10 min

6 min

5 min

4 min

2 min

1 min

30 s

20 s

20 s

10 s

10 s

9 s

4 s

-

FRAME 3D ON
FRAME 3D OFF

FIELD

SIF

• When a pre-recording area is created in an optional

extension unit (WJ-HDE300 series), it is possible to per-
form pre-event recording for up to 60 minutes accord-
ing to the resolution, recording rate and disk space for
pre-event recording. Refer to page 147 for descriptions
of how to create the pre-recording area.

• Pre-event recording for the camera channel that has the

pre-recording area in the extension unit will always be
performed on the pre-recording area.

• When a value that is impossible to be applied is set for

the pre-event recording, the relevant value will turn red,
and it will be impossible to close the recording program
window. In this case, lower the recording rate that has
turned red. 

■ 

■ 

■ 

■ 

■ 

■ 

■ 

■ 

■ 

■ 

■ 

■ 

■ 

■