Sharp CD-DD4500 ユーザーズマニュアル
22
To receive an FM stereo transmission:
Press the TUNER (BAND) button so that the “ST” indicator lights up.
“
j
” will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button so that the “ST” indi-
cator goes out. The reception changes to monaural, and the sound becomes clearer.
cator goes out. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the POWER button to enter the power stand-by mode.
Listening to the Radio
1
Press the POWER button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
frequency band (FM or AM).
3
Press the TUNING/TIME (
X
X
X
X
X
or
W
W
W
W
W
) button to tune in to the desired
station.
Manual tuning:
Press the TUNING/TIME button as many times as required to tune in to the
desired station.
desired station.
Auto tuning:
When the TUNING/TIME button is pressed for more than 0.5 seconds, scan-
ning will start automatically and the tuner will stop at the first receivable broad-
cast station.
ning will start automatically and the tuner will stop at the first receivable broad-
cast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at
that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/TIME button again.
that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/TIME button again.
FM stereo mode indicator
FM stereo receiving indicator
Radio
– Listening to the Radio –
Sound Control (See page 16.)