Sharp CD-DD4500 ユーザーズマニュアル
37
CD-DD4500
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
6
Press the TUNING/TIME (
W
W
W
W
W
or
X
X
X
X
X
) button to specify the minute,
then press the MEMORY/SET button.
7
The unit will enter the timer stand-by mode automatically.
To cancel the timer playback/timer recording:
Press the POWER button to turn the power on.
8
When the preset time is reached, playback or recording will start.
The volume will increase gradually until it reaches the volume you were listen-
ing at before your system enters the timer stand-by mode.
ing at before your system enters the timer stand-by mode.
9
In timer playback:
If you select CD or TAPE, the unit will enter the stand-by mode after the playback.
If you select TUNER or DVD/VCR, it will enter the stand-by mode one hour
after the timer playback starts.
If you select TUNER or DVD/VCR, it will enter the stand-by mode one hour
after the timer playback starts.
In timer recording:
When recording tape reaches its end, the timer recording will end, and the
unit will enter the stand-by mode.
unit will enter the stand-by mode.
The timer playback/timer recording setting will be canceled if any other op-
eration than volume control is performed during its operation.
eration than volume control is performed during its operation.
To reset or change the timer setting:
Perform “Timer playback or Timer recording” from the beginning.
Notes:
●
Once the time is set, the setting will be retained until a new time is entered.
●
When performing timer playback or recording using another unit connected to the
VIDEO/AUX IN or DIGITAL IN jacks, select “DVD/VCR” in step 2. At this time, only
this unit will be turned on or enter the power stand-by mode automatically. (Another
unit will not be turned on or turned off.)
VIDEO/AUX IN or DIGITAL IN jacks, select “DVD/VCR” in step 2. At this time, only
this unit will be turned on or enter the power stand-by mode automatically. (Another
unit will not be turned on or turned off.)
Timer and Sleep Operation (continued)
■
Sleep operation
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until “SLEEP” is dis-
played.
played.
To change the sleep time:
While the sleep time is displayed, press the TUNING/TIME (
X
or
W
) button.
(Maximum: 3 hours - Minimum: 1 minute)
●
3 hours - 5 minutes
→
5-minute intervals
●
5 minutes - 1 minute
→
1-minute intervals
3
Press the MEMORY/SET button.
4
Your system will enter the power stand-by mode automatically
after the preset time has elapsed.
after the preset time has elapsed.
The volume will be turned down 1 minute before the sleep operation finishes.
To cancel the sleep operation:
Press the POWER button while sleep operation is performed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button while sleep operation is performed.
The remaining sleep time is displayed for about 5 seconds.
The remaining sleep time is displayed for about 5 seconds.
Note
:
Once the sleep time is set, it will remain unchanged until the setting is changed.
Advanced Features
– T
imer and Sleep Operation –
■
Listening to the Radio (See page 22.)
*CD_DD4500_P36_39
2001.4.19, 11:43 PM
37