Denon PMD330 ユーザーズマニュアル

15

Command

Cord

Mode

2036-10

Preset

2041-12

END monitor

2043-10

CD-TEXT

2088

0

2000

1

2001

2

2002

3

2003

4

2004

5

2005

6

2006

7

2007

8

2008

9

2009

CD Sync start

1856

CD Sync stop

1857

This CD player can be controlled through its infrared

@9 on the front panel when it receives remote control signals

that supports RC5 signals as shown in the table at right.

These remote control codes can also be used if sent through

the RC5 

remote control jack

 b found on the rear panel of the

CD player.

Because the infrared remote sensor 

@9

 on the front panel of

the CD player and the RC5 remote control input jack on the

rear panel of the CD player both support the RC5 codes listed

in the table at right, this CD player can be controlled through

the infrared remote control sensor of any device that supports

RC5 codes.

* Remote control codes that are marked with an asterisk are

not supported by the PMD330.

The figure depicts the PMD331/PMD340.

Infrared remote control transmitter

Approximately 5 meters

 (15 feet)

This CD player has a CD SYNC function that makes it easy to

record for this CD player to be used in combination with a cas-

sette recorder.

The CD SYNC function works in combination with a cassette

deck that is equipped with the synchro recording function.

Connect the remote control jack (RC5) output

 

b

 

on this CD

player to the (RC5) input on the cassette deck, and then prepare

the cassette deck for synchro recording.

Refer to figure 2 for the connection method.

Put the cassette recorder into the synchro recording mode.

With the CD player in the stopped state, press the 

button !7 to start playing the CD.

The cassette recorder automatically begins recording.

This CD player can receive signals directly from an infrared remote control transmitter within about 5 meters (15 feet.)  Note that the

CD player might not operate correctly if the remote control transmitter is not pointed in the direction of the sensor on the CD player,

or if there is an obstacle between the transmitter and the sensor.

Area where an infrared remote control transmitter can be used

CD player (This unit)

60

°

When the CD player finishes playing, it stops and the cassette

recorder enters the paused state.

To continue recording, repeat this procedure, starting from

step 2.

- When performing synchro recording with a non-cassette recorder,

such as a CD-R or CD-RW recorder, the operation may differ,

so check the instruction manual provided with your recorder.

- When performing synchro recording, set preset menu No.17

“CD sync” to “On”.

- Make sure to set preset menu item No.1 “Auto Cue” to “Off”

and No.13 ”Start” to “Play” or “Stop” before utilizing CD Sync

function.

( See also page 17.)

RC5 Code chart

Command

Cord

Play

2053

Pause

2048

Cue

2059-10

Stop

2054

FF

2052

FR(REW)

2050

Index +

2034

Index -

2035

Next

2032

Previous

2033

Pitch +

2038

Pitch -

2039

Pitch Bend +

2038-10*

Pitch Bend -

2039-10*

A - B

2059

Program

2041

Pitch On/Off

2037

Open/Close

2045

Time

2011

INPUT

INPUT

OUTPUT

60°

約5m

赤外線リモコン送信機

CD

 P

LA

YE

R

--

+

+

--

+

+