Marantz CD6002 ユーザーズマニュアル

  Press the POWER button on the player to turn 

on the power.

  Press the OPEN/CLOSE 

0 button on the player 

or on the remote control. Place the CD to be 
played in the extended disc tray while ensuring 
that the label with the printed text is facing up.

 

In the case of a single (8 cm) CD, align it with 
the indentation in the center of the tray.

By using the remote control cable provided, connecting this player to additional Marantz audio equipment 
enables the connected equipment to be remote controlled as a single audio system.

  •  When connecting equipment incorporating a remote sensor, connect the “remote control out” connector 

of the equipment to the “remote control in” jack of the CD player. 

    When doing this, set this player’s switch to “EXTERNAL.” This will stop its remote control IR receiver 

from operating and the player can now be controlled via the remote control IR receiver of the attached 
equipment.

  •  When using this CD player alone, set the switch to “INTERNAL.”

AC IN

AC IN

INTERNAL

INTERNAL

EXTERNAL

EXTERNAL

OUT

OUT

IN

IN

L

L

R

R

OPTICAL

OPTICAL

COAXIAL

COAXIAL

DIGITAL AUDIO OUT

DIGITAL AUDIO OUT

REMOTE CONTROL

REMOTE CONTROL

ANALOG OUTPUT

ANALOG OUTPUT

MODEL NO. CD6002

MODEL NO. CD6002

:

Signal fl ow

Amplifi er

Remote connector cable (supplied)

Set to “EXTERNAL.”

  Plug the power cable into AC IN jack on the 

back panel.

  Turn on the power switch of the audio unit 

(amplifier, etc.) that is connected with this unit. 
Set the selector on the connected unit to this 
unit.

  Plug the power cable into an AC outlet.

CD6002N_01_ENG.indd   12

CD6002N_01_ENG.indd   12

07.6.20   1:09:14 PM

07.6.20   1:09:14 PM