Kohler 8002A ユーザーズマニュアル

2

1067580-AN2-D   14/11/11

G 1/2"

124 mm

89 mm

79 mm Min Clearance

67 mm

60 mm

Center of 

Water Inlet

All information is based on the latest product information available at the time 

of publication. Kohler Co. reserves the right to make changes in product 

characteristics, packaging, or availability at any time without notice. 

Please leave these instructions for the consumer.

1. Flush the water supply pipes thoroughly to remove any debris.

2. An in line water filter must be used with this product.

3. Inspect the supply pipes for damage. Replace as necessary.

4. Observe local plumbing codes.

5. The recommended working pressure for the shower head is 150KPa to 

    500KPa.  If the pressure exceeds 500KPa a pressure reducer is required.

6. Maximum water and environmental temperature for the shower head is 

60C. Note: If a heater is present, make sure to keep it away from the shower 

head as otherwise the environmental temperature may exceed 60C.

5IJTQSPEVDUNBZOPUCFTVJUBCMFGPSVTFXJUIDFSUBJOHSBWJUZGFEXBUFS

IFBUFSTPSMPXVOFRVBMQSFTTVSFTVQQMZOFUXPSLT

"MMJOTUBMMBUJPOTTIPVMEDPNQMZXJUISFMFWFOUSFRVJSFNFOUTPG"4/;4

and AS/NZS 6400.

                     For multiple outlets an operating pressure of 3.0 bar or greater is

recommended to ensure optimum performance. 

                                          (Hot) and Cold (C) inlets must be connected to the 

correct inlet supplies.

                                  Minimum building in depth is 79 mm. It is recommended that 

a minimum stud wall cavity of 100 mm is provided to ease installation.