American Standard 5500 プリント

Apply a bead of PUTTY along the edge of the underside of the body.

Insert FAUCET SHANKS (5) through holes in sink.

Assemble RUBBER (1) and BRASS WASHERS (2), and LOCKNUTS (3) from

underside of SINK.  Drop UPPER LIFT ROD (4) through hole in BODY

(models 5501 only), align BODY as far forward as possible

and secure position by tightening LOCKNUTS (3).

Connect the HOT water supply to the left SHANK and the COLD water

supply to the right SHANK using sealant, appropriate connectors, and

COUPLING NUTS.

BODY

PUTTY

SINK

6 0 1 8 4   R e v.   1 . 4

Remove AERATOR.
With handle in OFF position, turn on water supplies and check

all connections for leaks.

Operate both handles to flush water lines thoroughly.  Check

spout mounting and hose connections for leaks.

Operate LIFT ROD and check DRAIN for leaks.

Turn handles into OFF position and replace AERATOR.

To change direction of handle rotation, 

proceed as follows:

Turn valve to OFF position.

Remove HANDLE and BONNET NUT.

Remove SPRING CLIP.

Lift STOP WASHER, turn 90° and replace.

Replace SPRING CLIP.

Replace BONNET NUT, HANDLE, SCREW,

and INDEX.

AERATOR may accumulate dirt causing distorted and reduced

water flow.  Remove AERATOR and rinse clean.

If spout drips, operate handles several times from OFF to ON

position.  Do not force - handles turn only 90°.

Plastic SCREEN in CARTRIDGE may accumulate

dirt causing reduced water flow.  To clean, first

turn off hot and cold water supplies, then:

Remove HANDLE and BONNET NUT.

Remove CARTRIDGE by pulling up.

Thoroughly rinse plastic SCREEN at

base of CARTRIDGE.

Replace CARTRIDGE until flange is 

tight against valve body.

Turn valves OFF.

Replace BONNET NUT, HANDLE, SCREW

and INDEX.

Push TAILPIECE (1) down into TRAP

(threaded end up).
Thread LOCKNUT (2), WASHER (3) and

GASKET (4) onto DRAIN BODY (5).
Apply a bead of PUTTY to underside

of FLANGE (6).
Feed DRAIN BODY (5) up through SINK

and thread FLANGE (6) fully onto BODY (5).

Tighten LOCKNUT (2) firmly, keeping the

PIVOT ROD (7) pointed towards the back

of the SINK.

Drop STOPPER (8) into DRAIN BODY (5).

Pull TAILPIECE (1) up and thread tightly

into DRAIN BODY (5).

Position EXTENSION ROD (9) onto POP-UP

ROD (10) and tighten THUMBSCREW (11).

Remove one end of CLIP (12) from PIVOT ROD (7)

by squeezing ends together while sliding.

Insert PIVOT ROD (7) into second or third hole

in EXTENSION (9) and reassemble CLIP (12).

(EXTENSION may need to be bent.)

Adjust STOPPER (8) height by repositioning

EXTENSION and tightening THUMBSCREW (12).

SPRING

CLIP

STOP

WASHER

90°

Apply a bead of PUTTY around underside

of DRAIN PLUG FLANGE (1).  Insert DRAIN

PLUG (2) into SINK drain hole.

Hold DRAIN PLUG (2) to prevent turning

and assemble GASKET (3), WASHER (4)

and LOCKNUT (5) from underneath sink.

Insert threaded end of TAILPIECE (6) 

into lower end of DRAIN PLUG (2).

Connect other end to trap.