Tascam 302mkII ユーザーズマニュアル

You can press 

 on deck 2 to put deck 1 into

Play Pause mode and deck 2 into Record Pause
mode. 

9. To stop dubbing in NORM mode and exit this

mode, press 

 on deck 2. In HIGH SPEED

mode, you can press 

 on either deck. 

1. Connect the amp/speaker system to the OUTPUT

connectors of the deck you intend to use. 

2. Insert the tape into either deck 1 or 2. 

3. Make the following switch settings : 

 switch to Ä to play only one tape

side or ä to play both sides continuously. 

 switch depending on the tape in use. 

If REV MODE is set to Ä and you intend to play
only the reverse tape side, press the Ó button to
have the associated LED start blinking. 

4. To start play, press 

 whose LED is blinking. 

You can either connect a single amp/speaker system to
the deck 1’s output or an additional amp/speaker
system can be connected to the deck 2’s output as well. 

To have both decks play sequentially : 

1. Set the 

 switch to SEPARATE if

both decks’ outputs are in use or COMMON if only
deck l’s output is in use. 

2. Set the 

 switch to CONT. 

3. Insert the tapes into both decks. 

4. Set the 

 switch on both decks

depending on the tapes in use. 

5. To start sequential play, press 

 on deck 1. 

When deck 1 plays up to the end of the reverse side,
deck 2 automatically starts. When deck 1 plays up to
the end of the reverse side, deck 2 automatically starts
playing. When deck 2 plays up to the end af the reverse
side, deck 1 again starts playing. This process
continues until you press 

 on either deck.