Mitsubishi Electronics QJ71DN91 ユーザーズマニュアル
4 - 2 4 - 2
MELSEC-Q
4 SETUP AND PROCEDURES BEFORE OPERATION
4
4.1.2 When using the slave function
Start
Perform a hardware test (mode 9).
Set to mode 3 to 5.
Use
GX Configurator-DN?
Set "auto communication start
settings" using GX Configurator-DN
and load it to the QJ71DN91.
settings" using GX Configurator-DN
and load it to the QJ71DN91.
Create "parameters for the slave
function" using GX Configurator-DN.
function" using GX Configurator-DN.
Set "auto refresh" using GX
Configurator-DN and load it to the
QCPU.
Configurator-DN and load it to the
QCPU.
Create a sequence program for
control.
control.
Load the sequence program to the
QCPU and reset.
QCPU and reset.
Trial run?
Yes
No
Create a sequence program for "auto communication start
settings" and save it in the flash ROM of the QJ71DN91.
settings" and save it in the flash ROM of the QJ71DN91.
Create a sequence program for
refresh.
refresh.
Create a sequence program for
control.
control.
Load the sequence program to
the QCPU and reset.
the QCPU and reset.
Trial run?
End
Save the parameters using a
sequence program (Y17).
sequence program (Y17).
NG
OK
NG
OK
Setting the
presence of auto
communication
presence of auto
communication
Creating the
parameters for the
slave function
parameters for the
slave function
Setting refresh
Change the
number of I/O points of
the slave?
Create a sequence program to change
the number of I/O points of the slave.
the number of I/O points of the slave.
Yes
No