Conair Water/Spray Tanks ユーザーズマニュアル
Water/Spray Tanks
UGE014/0999
3-6
I
NSTALLATION
The standard WT.ST tanks are designed for use with city,
tower or chilled water supplies. You may choose to treat the
water to prevent algae build-up.
tower or chilled water supplies. You may choose to treat the
water to prevent algae build-up.
Connect the main water supply
to the 1
1
/
2
-inch
NPT fitting on the tank.
Connect the compressed air supply
to the fitting
on the tank air wipe compartment.
C
ONNECTING
THE
W
ATER AND
A
IR
S
UPPLIES
WARNING:
Do not use deionized water, brine
or other corrosive water mixtures for the main water
supply unless your tank has been specially designed
for such mixtures. Consult a water treatment special-
ist for the best way to prevent algae build-up without
damaging the equipment.
supply unless your tank has been specially designed
for such mixtures. Consult a water treatment special-
ist for the best way to prevent algae build-up without
damaging the equipment.
1
2
You can connect a chiller to the tank’s optional heat exchang-
er to remove heat from the extrudate more efficiently.
Typically, the tank comes with the 3/4 inch lines of the stan-
dard tube and shell heater plumbed to the tank’s water mani-
fold. The 1
er to remove heat from the extrudate more efficiently.
Typically, the tank comes with the 3/4 inch lines of the stan-
dard tube and shell heater plumbed to the tank’s water mani-
fold. The 1
1
/
2
inch inlet and outlet of the heat exchanger can
be used for the chiller.
For maximum water flow:
Connect the chiller “To Process” and “From Process” lines to
the largest NPT fittings in the shell of the heat exchanger.
the largest NPT fittings in the shell of the heat exchanger.
For maximum cooling efficiency:
Connect the chiller “To Process” and “From Process” lines to
the smallest NPT tube ends of the heat exchanger.
the smallest NPT tube ends of the heat exchanger.
TIP: If you have a water
supply with high mineral
content, connect the chiller
to the tube ends of the
heat exchanger.
supply with high mineral
content, connect the chiller
to the tube ends of the
heat exchanger.
C
ONNECTING A
C
HILLER
From chiller
To chiller
To water manifold
From water
pump
pump
From chiller
To chiller
To water manifold
From water pump