Atlas MLGC240W ユーザーズマニュアル
Mode:
On-Time:
Works:
Day
Night
Test
5 Seconds
x
x
Auto
1, 5, 20 min.
x
Manual
Until Dawn*
x
Accent
3, 6 Hr, to Dawn
x
OPERATION
* resets to Auto Mode at dawn.
MANUAL MODE
ON-TIME
20 5 1 TEST
... back on.
AUTO
1 Second OFF
then...
Move ON-TIME Switch to 1,
5, or 20 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
Requirements
• The Light Control requires 120-volts AC.
• If you want to use Manual Mode, the control must be
• If you want to use Manual Mode, the control must be
wired through a switch.
• Some codes require installation by a qualified
electrician.
• This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
locations.
Light Control
Sensor
Cover
Plate
Lamp Holders
2 Wire
Connectors
6 Screws
(3 sizes included)
Gasket
Features
• Turns on lighting when motion is detected.
• Automatically turns lighting off.
• Dual Light Level
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
• Automatically turns lighting off.
• Dual Light Level
• Photocell keeps the lighting off during daylight hours.
• LED indicates motion was sensed (day or night).
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.
calibration time the control will be in the AUTO mode.
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
Mounting Bolt
Mounting Strap
Plastic Hanger
Rubber Plug
Models MLGC240B
MLGC240W
GUARDIAN
PRO
™
240 S
ERIES
240-028-A
© 2003 Atlas Lighting Products, Inc.
598-1094-01
This package includes:
Put the ON-TIME switch in the 1, 5, or
20 minute position.
20 minute position.
Manual mode only works at night
because daylight returns the sensor
to AUTO.
because daylight returns the sensor
to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
ON-TIME switch in the 1, 5, or 20
position.
2 Shells
TEST
TEST 1 5 20
ON-TIME
Off 3 6 Dusk to Dawn
DUAL LIGHT LEVEL
Put ON-TIME switch on the sensor bottom to TEST
and the Dual Light Level switch OFF.
and the Dual Light Level switch OFF.
Dual Light Level Control
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). If motion is sensed, the
light turns on full bright for the ON-TIME (1, 5, or 20
minutes) then returns to dim mode.
(Off, 3 hr., 6 hr., until dawn). If motion is sensed, the
light turns on full bright for the ON-TIME (1, 5, or 20
minutes) then returns to dim mode.