Yamaha RX-V3900 ユーザーズマニュアル

y

It is recommended that you use a tripod (etc.) to affix the 
optimizer microphone at the same height as your ears 
would be when you are seated in your listening position. 
You can use the attached screw of a tripod (etc.) to fix the 
optimizer microphone to the tripod (etc.).

Press 9

ENTER to start the measurement.

This unit starts to count down from 10 seconds.

y

• To start the measurement immediately, press 9ENTER 

again.

• To cancel the automatic setup and return to the previous 

screen, press 0RETURN.

Loud test tones are output from each speaker during 
the measurement. Once all items are measured, 
“COMPLETED” appears.

If an error or warning message appears, see “Automatic 
setup” (page 136).

y

You can check the results of the measurements by using 
the GUI screen (page 34).

Use this feature to optimize the setup of this unit this unit 
for one listening position. You can also select the 
parameters to be optimized in the automatic setup.

Press I

MENU on the remote control.

The following screen (GUI menu) appears in the 
video monitor.

To select the parameters to be optimized, 
press 9k to select “Setup Menu” and then 
press 9h.
When you do not need to select the parameters to be 
optimized, skip to step 6.

y

If you do not select the parameters to be optimized, this 
unit will optimize the parameters you selected last time. 
All the parameters are selected by the initial factory 
settings.

Press 9k / n repeatedly to select the 
parameter and then press 9

ENTER to 

check or uncheck the box.
Check the boxes for the parameters to be optimized.

Once you perform the next operation, this unit starts the 
automatic setup procedure in 10 seconds. During the 
automatic setup procedure, do not perform any operation on 
this unit. For more accurate measurements, we recommended 
that you get out of the room or move to the wall where 
speakers are not around during the measurement. It takes 
approximately 3 minutes.

C O M P L E T E D

P L S U N P L U G M I C

E R R O R : E - 0 1

P R E S S E N T E R

Multi Measure 
(Multiple point 
measurement)

You can optimize the setup of this unit for 
multiple listening positions. For details, see 
“Advanced automatic setup” (page 33). In 
the basic automatic setup, leave this setting 
to the default.

Wiring 
(Speaker wiring)

This unit checks and adjusts which speakers 
are connected and the polarity of each 
speaker.