Yamaha RX-V361 ユーザーズマニュアル

Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. If the connections are faulty, 
this unit cannot reproduce the input sources accurately.

■ Before connecting to the SPEAKERS 

A speaker cord is actually a pair of insulated cables 
running side by side. Cables are colored or shaped 
differently, perhaps with a stripe, groove or ridges. 
Connect the striped (grooved, etc.) cable to the “+” (red) 
terminals of this unit and your speaker. Connect the plain 
cable to the “–” (black) terminals.

• Use speakers with the specified impedance shown on the rear panel of this unit.
• If you are to use 6 ohm speakers, be sure to set “SP IMP.” to “6

Ω MIN” before using this unit (see page 13).

• Before connecting the speakers, make sure that this unit is turned off.
• Do not let the bare speaker wires touch each other or let them touch any metal part of this unit. This could damage 

this unit and/or speakers.

• Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the 

speakers away from the monitor.