Yamaha RX-V361 ユーザーズマニュアル

Both FM and AM indoor antennas are supplied with this 
unit. In general, these antennas should provide sufficient 
signal strength. Connect each antenna correctly to the 
designated terminals.

• The AM loop antenna should be placed away from this unit.
• A properly installed outdoor antenna provides clearer reception 

than an indoor one. If you experience poor reception quality, 
install an outdoor antenna. Consult the nearest authorized 
Yamaha dealer or service center about outdoor antennas.

• The AM loop antenna should always be connected, even if an 

outdoor AM antenna is connected to this unit.

Once all connections are complete, plug the power cable 
into the AC wall outlet.

■ Turning on this unit

Press 1

STANDBY/ON (or LPOWER) to turn 

y

When you turn on this unit, there will be a 4 to 5-second delay 
before this unit can reproduce sound.

■ Set this unit to the standby mode

Press 1

STANDBY/ON (or MSTANDBY) to set 

this unit to the standby mode.
In the standby mode, this unit consumes a small amount of 
power in order to receive infrared signals from the remote 
control.

For maximum safety and minimum 
interference, connect the antenna GND 
terminal to a good earth ground. A good 
earth ground is a metal stake driven into 
moist earth.

Use a 5 to 10 m (16 to 32 ft) of 
vinyl-covered wire extended 
outdoors from a window.