Yamaha RX-V361 ユーザーズマニュアル

■ Speaker distance  

C)SP DISTANCE

Use this feature to manually adjust the distance of each 
speaker and the delay applied to the respective channel. 
Ideally, each speaker should be the same distance from the 
main listening position. However, this is not possible in 
most home situations. Thus, a certain amount of delay 
must be applied to the sound from each speaker so that all 
sounds will arrive at the listening position at the same 
time.

  UNIT

Choices: meters (m), feet (ft)
Initial setting:
[U.S.A. and Canada models]: feet (ft) 
[Other models]: meters (m)
• Select “meters” to adjust speaker distances in meters.
• Select “feet” to adjust speaker distances in feet.

Speaker distances
Control range: 0.30 to 24.00 m (1.0 to 80.0 ft)
Control step: 0.10 m (0.5 ft)
Initial setting: 3.00 m (10.0 ft)

The available speaker channels differ depending on the setting of 
the speakers.

■ Center graphic equalizer  

D)CENTER GEQ

Use this feature to adjust the built-in 5-frequency band 
(100Hz, 300Hz, 1kHz, 3kHz and 10kHz) graphic 
equalizer for the center channel so that the tonal quality of 
the center speaker matches that of the front speakers. You 
can make adjustments while listening to the currently 
selected source component or a test tone.

Control range: –6.0 to +6.0 dB
Control step: 0.5 dB
Initial setting: 0 dB

y

Press 

G

 k / n to select a frequency band and 

G

 l / h to adjust 

the selected frequency band.

Following is an example where “100Hz” is selected as the 
frequency band.

TEST

Use this feature to make adjustments for “CENTER GEQ” 
while listening to a test tone.
Choices: OFF, ON
• Select “OFF” to stop test tones and output the currently 

selected source component.

• Select “ON” to output test tones from the center and 

front left speakers.

■ Low-frequency effect level  

E)LFE LEVEL

Use this feature to adjust the output level of the LFE (low-
frequency effect) channel according to the capacity of 
your subwoofer or headphones. The LFE channel carries 
low-frequency special effects which are only added to 
certain scenes. This setting is effective only when this unit 
decodes Dolby Digital or DTS signals.

Control range: –20 to 0 dB
Control step: 1 dB

  SP LFE

Adjusts the speaker LFE level.

  HP LFE

Adjusts the headphone LFE level.

Depending on the settings of “BASS OUT” (see page 46), some 
signals may not be output at the SUBWOOFER OUTPUT jack.

■ Dynamic range  

F)D. RANGE

Use this feature to select the amount of dynamic range 
compression to be applied to your speakers or 
headphones. This setting is effective only when this unit is 
decoding Dolby Digital and DTS signals.

Choices: MIN, STD, MAX
• Select “MIN” (minimum) if you regularly listen at low 

volume levels.

• Select “STD” (standard) for general use.
Select “MAX” (maximum) to preserve the greatest 
amount of dynamic range.

  SP D.R

Adjusts the speaker compression.

  HP D.R

Adjusts the headphone compression.

FRONT L

Front left speaker

FRONT R

Front right speaker

CENTER

Center speaker

SUR. L

Surround left speaker

SUR. R

Surround right speaker

SWFR

Subwoofer

100Hz--||--  0