Yamaha RX-V661 ユーザーズマニュアル

ページ / 130
14
 En
Connections
■ Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of 
insulation from the end of each speaker 
cable and then twist the exposed wires of the 
cable together to prevent short circuits.
2
Loosen the knob.
3
Insert one bare wire into the hole on the side 
of each terminal.
4
Tighten the knob to secure the wire.
■ Connecting the banana plug 
(except Europe, Asia and Korea models)
Tighten the knob and then insert the banana 
plug connector into the end of the 
corresponding terminal.
■ Using bi-amplification connections
This unit allows you to make bi-amplification connections 
to one speaker system. Check if your speakers support bi-
amplification. 
To make the bi-amplification connections, use the FRONT 
and SURROUND BACK terminals as shown below. To 
activate the bi-amplification connections, set “BI-AMP” 
to “ON” in “ADVANCED SETUP” (see page 95).
When you make the conventional connection, make sure that the 
shorting bars are put into the terminals appropriately. Refer to the 
instruction manuals of the speakers for details.
10 mm (0.4 in)
Red: positive (+)
Black: negative (–)
Caution
Remove the shorting bars or bridges to separate the 
LPF (low pass filter) and HPF (high pass filter) 
crossovers.
Note
Red: positive (+)
Black: negative (–)
FRONT A
SURROUND BACK/
BI-AMP
SINGLE
L
R
L
R
This unit
Left
Right
Front speakers