Yamaha RX-V1900BL ユーザーズマニュアル

Press F

SETUP again to exit the setup 

• “ERROR” appears in the display window (4) on the remote 

control if you press a button not indicated in the respective step, 
or when you press more than one button simultaneously.

• This remote control can learn approximately 200 functions. 

However, depending on the signals learned, “FULL” may 
appear in the display before you program 200 functions. In this 
case, clear unnecessary programmed functions to make room 
for further learning (page 97).

• Learning may not be possible in the following cases:

– when the batteries in the remote control for this unit or other 

components are weak.

– when the remote control is exposed to direct sunlight.
– when the function to be programmed is continuous or 

uncommon.

You can change the name of the control area (input 
source) that appears in the display window (4) on the 
remote control.

Set the operation mode selector to 
E

SOURCE and then press an input selector 

button (3) to select the desired control area.

Press F

SETUP using a ballpoint pen or 

similar object.
“SETUP” appears in the display window.

Press 8k / n repeatedly to select “RNAME” 
and then press 8

ENTER.

Press 8k / n repeatedly to select 3-letter 
name or 5-letter name you want to edit and 
then press 8

ENTER.

Each control area has both 3-letter name and 5-letter 
name. You can rename the 3-letter name and 5-letter 
name independently.

Edit the name of the control area.
To locate the position to edit , press 8l / h.
To select a character, press 8k / n.

y

Press 8k to change the character in the following order, 
or press 8n to go in the reverse order: A to Z, a to z, 0 to 
9, space, symbols (–, +, /, :).

Press 8

ENTER to set the new name.

“OK” appears in the display window (4) on the 
remote control if renaming was successful.

y

When you want to rename the another control area, press 
the input selector button (3) or 5SELECT l / h 
repeatedly to select the desired control area and then press 
8ENTER and then carry out the operations of steps 4 
through 6.

Press F

SETUP again to exit the setup 

“ERROR” appears in the display window (4) on the remote 
control if you press a button not indicated in the respective step, 
or when you press more than one button simultaneously.

BD

BD/HD

BD/HD