Integra DTR-10.5 ユーザーズマニュアル

 

49

 

You can turn on the AV devices connected to the 
DTR-10.5 automatically using the output signal from the 
12V TRIGGER OUT terminal on the DTR-10.5.

 

You can connect up to five devices to the 12V TRIGGER 
Phoenix (Pluggable Connector) terminal (larger one) 
and one device to the 12V TRIGGER OUT E terminal 
(mini-jack).
You can connect any external devices to the DTR-10.5 
whether the connected device is located in the main, 
Zone 2 or Zone 3 room.

 

Up to 200 mA.

 

Up to 100 mA each.

 

Up to 100 mA for the total current value of both the 
Phoenix and mini-jack terminals.

Before connecting an external device, check that the cur-
rent value for the 12V TRIGGER terminal of the con-
nected device does not exceed the target terminal’s 
maximum current above.

 

1. Loosen the screws using a flatblade screwdriver to 

open the shutters.

2. Connect the GND wire (black) to the GND terminal, 

and close the shutter.

3. Connect the remaining wire to any of the terminals 

between A and E, and close the shutter.

4. When you connect more than one external device, 

you can connect all the GND wires to the GND ter-
minal together.

5. Connect the Phoenix terminal firmly to the 12V 

TRIGGER OUT socket on the DTR-10.5.

6. After making connections, you have to configure the 

association between the room where the device is 
used and the device to be turned on. For performing 
this setting, refer to “12V Trigger Assign” of “Input 
Setup” section on page 98.

 

When you want to connect two devices to both the Phoe-
nix terminal E and mini-jack terminal simultaneously, 
you can connect them as long as the total current value of 
their 12V TRIGGER terminals will not exceed 100 mA

 

.

A
B
C
GND
D
E

A
B
C
GND
D
E

200mA MAX
100mA MAX
100mA MAX

100mA MAX
TOTAL 100mA MAX