Integra DTR-7.4 ユーザーズマニュアル

31

Selecting the Appropriate Setting for Your Connections—Continued

Zone 2: Select when connecting the speakers for the 
remote zone (Zone 2) to the SURR BACK/ZONE 2 
PRE OUT or SURR BACK/ZONE 2 SPEAKERS 
terminals (for using the internal amplifier for Zone 2).
Surr Back (default): Select when not connecting 
the speakers for the remote zone (Zone 2) to the 
SURR BACK/ZONE 2 PRE OUT or SURR BACK/
ZONE 2 SPEAKERS terminals (for using the inter-
nal amplifier for the surround back speakers).

Note:
The SURR BACK/ZONE 2 PRE OUT and SURR 
BACK/ZONE 2 SPEAKER terminals
In order to have 7.1 channel playback in the main room, 
you must set the Surr Back/Zone 2 setting to “Surr 
Back.” When set to “Surr Back,” the surround back 
signals are output from the SURR BACK/ZONE 2 PRE 
OUT and SURR BACK/ZONE 2 SPEAKER terminals. 
Connect the surround back speakers to the SURR 
BACK/ZONE 2 SPEAKER terminals or to the speakers 
terminals of the power amplifier connected to the SURR 
BACK/ZONE 2 PRE OUT terminals.
When you are not using the surround back speakers in the 
main room and are using the internal amplifier to power the 
speakers for the remote zone (Zone 2), set the Surr Back/
Zone 2 setting to are “Zone 2.” When set to “Zone 2,” the 
Zone 2 signals are output from the SURR BACK/ZONE 2 
PRE OUT and SURR BACK/ZONE 2 SPEAKER 
terminals. Connect the remote zone (Zone 2) speakers to 
the SURR BACK/ZONE 2 SPEAKER terminals or to the 
speaker terminals of the power amplifier connected to the 
SURR BACK/ZONE 2 PRE OUT terminals.
At this time, the main room is switched to 5.1 channel 
playback mode, and therefore you cannot select the THX 
Surround EX, Dolby Digital EX or DTS-ES, which 
requires the surround back speakers.

Use this sub-menu when you have a remote control 
sensor connected to the IR IN terminal. The setting in 
this sub-menu tells the DTR-7.4 whether the remote 
control sensor is being used for operation of the 
DTR-7.4 in the main zone or the remote zone (Zone 2).

Main: Select when you are using the remote control 
sensor for operation with the remote controller in the 
main zone.
Zone 2: Select when you are using the remote 
control sensor for operation with the remote 
controller in the remote zone (Zone 2). 

This section explains how to change the DTR-7.4’s 
remote control ID. You may need to change this if the 
DTR-7.4’s remote controller interferes with other 
Integra/Onkyo components located in the same room.

Note:
If you change the DTR-7.4’s remote control ID, be 
sure to select the same ID on the remote controller 
(See the next section). The default ID for both the 
DTR-7.4 and remote controller is 1.

0-2.Surr Back/Zone2
      
      
 a.Surr Back/Zone2
                :Zone2
  

 

 

 

            Quit:[SETUP]

0-3.Remote Setup
      
      
 a.Position     :Main

 b.Remote ID    :1
  

 

 

 

            Quit:[SETUP]