ONKYO tx-nr545 ユーザーズマニュアル

Step 3:   Playing Back

6 

You can listen to audio in a room (called Zone 2) other than 

the one where this unit is located (called the main room).



 

● External players (1) 

 

● NET (2)

 

● Bluetooth

 

● AM/FM Radio



1  Only analog audio signals can be output to Zone 2.



2  DSD and Dolby TrueHD audio signals cannot be output to Zone 2.

Important: Connection with external players

To listen to a player in Zone 2, you must connect using an 

RCA cable. Some players may require analog audio output 

setting.

There are the following two methods of connection:

a.  Connecting with a pre-main amplifier in a separate room

b.  Connecting with speakers in a separate room



It is possible to play 2 ch source in a separate room while 

7.1 ch source is being played in the main room.

Connect the LINE OUT ZONE2 jacks of the unit and the 

line-in jacks of the pre-main amplifier in a separate room 

with an RCA cable.

Main room

Zone 2

 

● The volume should be adjusted with the pre-main 

amplifier used in the separate room.



Connect the speakers in another room to the SPEAKERS 

ZONE2 jacks of the unit using speaker cables. Note that 

5.1 ch will be the maximum () in the main room during 

Zone 2 playback. No sound will be output from the back 

speakers and height speakers.

¼



In this case, the Dolby Atmos listening mode cannot be selected.

Main room

Zone 2

These settings are required: After connecting the 

speakers, press 

RECEIVER and then SETUP 

on the remote controller, select "2. Speaker" - 

"Configuration" and set "Powered Zone2" to "Yes".

 

● Adjust the volume on this unit. To adjust the 

volume, press ZONE2 on the remote controller 

and then adjust with VOL

j/l. To control on the 

main unit, press ZONE 2 and within 8 seconds, 

adjust with the MASTER VOLUME control. You 

can mute the sound by pressing MUTING on the 

remote controller.