ONKYO tx-nr545 ユーザーズマニュアル

Connecting and Operating Onkyo RI Components

Connecting an Onkyo component with RI jack such as 

the separately sold RI Dock to the unit by using an RI 

cable and an analog audio cable enables the following RI 

functions:
System On / Auto Power On: Starting playback on a 

component connected via RI when the unit is on standby 

mode, automatically turns on the unit to select the relevant 

component as its input source.
Direct Change: When playback is started on a component 

connected via RI, the unit selects that component as the 

input source.
Remote Controller Operation: Allows you to operate 

RI-compatible Onkyo components using the AV receiver's 

remote controller. Point the remote controller at remote 

control sensor of the unit. This operation is possible only 

when the RI remote control code is programmed.

● Some components may not support all RI functions.

● These functions do not work when Zone 2 is turned on.

● For information on the RI functions, also refer to each 

component's instruction manual.

Connect an Onkyo component with RI jack to this unit using 

an RI cable and an analog audio cable. For details, refer 

to the instruction manual of the component with RI jack. 

The RI cable can be connected in any order. When there 

are two RI jacks, both jacks work in the same way and are 

interchangeable.

To connect the RI Dock or cassette tape deck via RI, the 

following settings are required.

¼



To make the RI functions work, you must rename the input 

selectors on the unit. Press CD or GAME to display "CD" 

or "GAME" on the main unit display. Then press and hold 

CD or GAME 3 seconds or more to switch the display to 

"DOCK" or "TAPE".

¼



Program the remote control code to any REMOTE MODE 

button on the remote controller. This will allow you to 

operate the component by pointing the remote controller at 

the unit instead of the component.

1.  Press and hold DISPLAY for 3 or more seconds while 

holding down the REMOTE MODE button to which you 

want to program the remote control code.

● The remote indicator will light.

● The RECEIVER and ZONE2 buttons cannot be 

programmed.

2.  With the number buttons, enter the following 5-digit 

remote control code within 30 seconds.

RI Dock: 81993

Cassette tape deck with RI jack: 42157

● Programming is complete when the remote indicator 

flashes twice. The remote indicator flashes once 

slowly when programming the remote control code 

fails. Try programming again.

Input selector on the RI Dock: Switch to "DOCK" or 

"TAPE"

� For details, refer to the RI Dock's instruction 

manual.

To operate Onkyo components directly or Onkyo 

components that are not connected via RI, use the 

following remote control codes:

Onkyo DVD player: 30627

Onkyo CD player: 71817

RI Dock: 82990

● With some models, operation may be not possible in 

part or not possible at all.