ONKYO 29400095 ユーザーガイド

52

You can temporarily mute the output of the AV receiver.

With the sleep timer, you can set the AV receiver to turn 
off automatically after a specified period.

If you need to cancel the sleep timer, press the [SLEEP] 
button repeatedly until the SLEEP indicator disappears.

To check the time remaining until the AV receiver sleeps, 
press the [SLEEP] button. Note that if you press the 
[SLEEP] button while the sleep time is being displayed, 
you’ll shorten the sleep time by 10 minutes. 

You can connect a pair of stereo headphones (1/4-inch 
phone plug) to the AV receiver’s PHONES jack for pri-
vate listening, as shown.

Notes:
• Always turn down the volume before connecting your 

headphones.

• While the headphones plug is inserted in the PHONES 

jack, the speakers are turned off. (The Powered Zone 
2 speakers are not turned off.)

• When you connect a pair of headphones, the listening 

mode is set to Stereo, unless it’s already set to Stereo, 
Mono, or Direct.

• Only the Stereo, Direct, and Mono listening modes 

can be used with headphones (the listening modes 
available also depend on the currently selected input 
source).

Press the [RECEIVER] button, 
and then press the [MUTING] but-
ton.
The output is muted and the MUTING 
indicator flashes on the display, as 
shown.

To unmute the AV receiver, press the 
[MUTING] button again, or adjust the 
volume.
The Mute function is cancelled when 
the AV receiver is set to Standby.

Press the [RECEIVER] button, 
and then press the [SLEEP] but-
ton repeatedly to select the 
required sleep time.
The sleep time can be set from 90 to 10 
minutes in 10 minute steps.

The SLEEP indicator appears on the 
display when the sleep timer has been 
set. The specified sleep time appears on 
the display for about five seconds, then 
the previous display reappears.