ONKYO 29400095 ユーザーガイド

83

If you’ve connected your Zone 2 speakers to the AV 
receiver, as explained in “Connecting Your Zone 2 
Speakers Directly to the AV receiver” on page 82, you 
must set the “Powered Zone 2” setting to “Act” (Acti-
vated).

Notes:
• When “Act” is selected and Zone 2 turned on, the 

Zone 2 speakers connected to the ZONE 2 L/R 
speaker terminals output sound, but the surround back 
or front high speakers connected to the SURR BACK/
FRONT HIGH L/R speaker terminals do not. When 
“Act” is selected and Zone 2 turned off, the surround 
back or front high speakers output sound as normal.

• When the “Powered Zone 2” setting is set to “Act” 

and the input selector of Zone 2 is selected, power 
consumption on standby mode slightly increases.

• Powered Zone 2 cannot be used if “Speaker Type” is 

set to “Bi-Amp” (see page 42).

• This procedure can also be performed on the AV 

receiver by using its [SETUP] button, arrow buttons, 
and [ENTER] button.

Press the [RECEIVER] button 
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make 
sure the appropriate external input is 
selected on your TV.

q]/[w] 

buttons to select “2. Speaker 
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.

q]/[w] 

buttons to select “1. Speaker 
Settings”, and then press 
[ENTER].
The “Speaker Settings” menu appears.

q]/[w] 

e]/[r] buttons to select:

ZONE 2 L/R speaker terminals not 
activated (Powered Zone 2 dis-
abled).

ZONE 2 L/R speaker terminals 
activated (Powered Zone 2 
enabled).

Press the [SETUP] button.
The setup menu closes.