ONKYO 29400021 ユーザーズマニュアル
65
Changing Source Component
When you want to operate the component that is not
assigned as the source component, you can assign it as
the source component. For the default assignment, see
page 135.
assigned as the source component, you can assign it as
the source component. For the default assignment, see
page 135.
Switching Normal Macro Mode
You can switch the AV receiver to normal macro mode
from Easy macro mode, and vice versa. In the normal
macro mode, you can use macro commands (see
page 137).
from Easy macro mode, and vice versa. In the normal
macro mode, you can use macro commands (see
page 137).
Restore Default
(3 seconds)
While holding down the REMOTE
MODE button, press and hold
down the [MY MOVIE], [MY TV],
or [MY MUSIC] button (about 3
seconds).
The ACTIVITIES buttons that you
pressed flashes twice, indicating that
the setting has been established.
MODE button, press and hold
down the [MY MOVIE], [MY TV],
or [MY MUSIC] button (about 3
seconds).
The ACTIVITIES buttons that you
pressed flashes twice, indicating that
the setting has been established.
Examples:
When you press the [MY MUSIC] but-
ton and want to start the Onkyo Cas-
sette recorder, while holding down
[TV/TAPE] button, press and hold
down the [MY MUSIC] button (about
3 seconds) flashes twice.
When you press the [MY MUSIC] but-
ton and want to start the Onkyo Cas-
sette recorder, while holding down
[TV/TAPE] button, press and hold
down the [MY MUSIC] button (about
3 seconds) flashes twice.
(3 seconds)
While holding down the
[RECEIVER] button, press and
hold down the ACTIVITIES but-
tons (about 3 seconds).
[RECEIVER] button, press and
hold down the ACTIVITIES but-
tons (about 3 seconds).
Note:
Once the AV receiver has entered the
normal macro mode, all of the ACTIV-
ITIES buttons will automatically
switch to the Normal macro mode. In
this case, pressing the [ALL OFF] but-
ton will only set the AV receiver to
Standby mode.
Once the AV receiver has entered the
normal macro mode, all of the ACTIV-
ITIES buttons will automatically
switch to the Normal macro mode. In
this case, pressing the [ALL OFF] but-
ton will only set the AV receiver to
Standby mode.
1
(3 seconds)
While holding down the [AUDIO]
button, press and hold down the
[ALL OFF] button until the [ALL
OFF] button lights up (about 3
seconds).
button, press and hold down the
[ALL OFF] button until the [ALL
OFF] button lights up (about 3
seconds).
2
Release the [AUDIO] and [ALL
OFF] buttons and press the [ALL
OFF] button again.
The [ALL OFF] button flashes twice.
OFF] buttons and press the [ALL
OFF] button again.
The [ALL OFF] button flashes twice.
TX-NR807_En.book Page 65 Tuesday, July 28, 2009 12:00 PM