Marantz SR4002/SR5002 ユーザーズマニュアル

You can select the display mode for the front display 
of the unit.
To select this mode, press the DISPLAY on the 
remote controller.
When this button is pressed, the display mode is 
switched in the following sequence.
→ Surround Mode → Auto-display Off → Display Off 
→ Input Function → Surround Mode....
In Auto display off mode, the display is off. But, if you 
make a change to the unit such as input or surround 
mode, the display will show that change, then go 
back to off after about 3 seconds. When changing the 
volume, it is not displayed.
In Display off mode, the display is off completely.

Only the DISP indicator will be illuminated on the 
front display in display off condition

In normal operation, the audio or video source 
selected for listening through this unit is sent to the 
record outputs.
This means that any program you are watching 
or listening to may be recorded simply by placing 
machines connected to the outputs for TAPE OUT, 
CD/CDR OUT, VCR OUT in the record mode.

 

  Select the input source to record by turning the 

INPUT SOURCE knob on the front panel or 
simply press the input selector buttons on the 
remote controller.

 

  The input source is now selected and you may 

watch or listen to it as desired.

 

  The currently selected input source signal is 

output to the TAPE OUT, CD/CDR OUT, VCR 
OUT outputs for recording. 

  Start recording to the recording component as 

desired.

Recording the video from one source and 
the audio from another
You can add the sound from one source to the 
video of another source to make your own video 
recordings.
Below is an example of recording the sound from 
a compact disc player connected to CD IN and the 
video from a video camera connected to DSS to 
video cassette recorder connected to the VCR OUT 
jack.

 

  Switch the video output source to VCR by 

simply pressing the input selector buttons on 
the remote controller.

 

  Switch the audio input source to CD by simply 

pressing the input selector buttons on the 
remote controller.

  Now “CD” has been selected as the audio input 

source and “VCR” as the video input source.

•  If you change the input source during recording, you 

will record the signals from the newly selected input 
source.

•  You cannot record the surround effects.

• Digital input signals are only output to the digital 

outputs. There is no conversion from digital to 
analog.

  When connecting CD players and other digital 

components, do not connect only the digital 
terminals, but the analog ones as well.

If you have already assigned the digital inputs, you 
can temporarily select the audio input mode for each 
input source as following procedures.
Press the AMP button and press the A/D (0) button. 
When this button is pressed, the input mode is 
switched in the following sequence.
→ HDMI Auto → HDMI → Digital → Analog → HDMI 

Auto....

In HDMI Auto mode, the types of signals being input 
to the digital and analog input jacks for the selected 
input source are detected automatically.
If no digital signal is being input, the analog input 
jacks are selected automatically.
In Digital and HDMI mode, input is fixed to an 
assigned digital input terminal.
In analog mode, the analog input jacks are selected.
This selecting is temporary, so the result will not be 
stored in memory.
If you need to change the input mode completely, use 
INPUT SETUP in OSD menu system. (see page 27)

SR4002-5002U DFU_01_E2_2.indd   39

SR4002-5002U DFU_01_E2_2.indd   39

07.7.9   2:47:38 PM

07.7.9   2:47:38 PM