Pioneer VSX-819H-S ユーザーズマニュアル

En

Considerable noise in radio 
broadcasts.

• Connect the antenna (page 20) and adjust the position for best reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and secure to a wall 
(or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 21).
• Turn off equipment causing interference or move it away from the receiver (or 
move antennas farther away from equipment causing noise).

Broadcast stations cannot be 
selected automatically.

• Connect an outdoor antenna (refer to page 21).

Noise during playback of a 
cassette deck.

• Move the cassette deck away from your receiver, until the noise disappears.

Sound is produced from other 
components, but not from LD 
or DVD player.

• Set the 

SIGNAL SEL to HDMI, C1/O1/O2 (DIGITAL) or A (analog) according to the 

type of connections made (refer to page 41).
• Set the digital input settings correctly (refer to page 45).
• Make digital connections (refer to page 14) and set the 

SIGNAL SEL to C1/O1/O2 

(

DIGITAL) (refer to page 41).

• Refer to the instruction manual supplied with the DVD player.

No sound is output or a noise 
is output when software with 
DTS is played back.

• Set the digital volume level of the player to full, or to the neutral position.
• Make sure the player’s settings are correct and/or the DTS signal out is on. Refer 
to the instruction manual supplied with the DVD player.
• Set the input signal type to 

C1/O1/O2 (DIGITAL) (see Choosing the input signal on 

page 41).

During a playback search, 
noise is output from a DTS 
compatible CD player.

• This is not a malfunction, but be sure to turn the volume down to prevent the 
output of loud noise from your speakers.

Everything seems to be set up 
correctly, but the playback 
sound is odd.

• Check that the positive/negative speaker terminals on the receiver are matched 
with the corresponding terminals on the speakers (see Connecting the speakers on 
page 22).

There seems to be a time lag 
between the speakers and the 
output of the subwoofer.

• See Automatically setting up for surround sound (MCACC) on page 9 to set up your 
system again using MCACC (this will automatically compensate for a delay in the 
subwoofer output).

After using the Auto MCACC 
Setup, the speaker size setting 
(

LARGE or SMALL) is incorrect.

• Low-frequency noise could have been caused by an air conditioner or motor. 
Switch off all appliances in the room and rerun the Auto MCACC Setup.

Can’t operate the remote 
control.

• Replace the batteries (refer to page 7).
• Operate within 7 m, 30

°

 of the remote sensor (refer to page 28).

• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.

The display is dark or off.

• Press 

DIMMER on the control repeatedly to return to the default. 

VSX-819H_RLF.book  67 ページ  ２００９年１月２０日　火曜日　午前１０時３６分