Pioneer VSX-919AH-K ユーザーズマニュアル

En

ENTER.
A progress report is displayed on-screen while 
the receiver outputs more test tones to 
determine the optimum receiver settings for 
channel level, speaker distance, and Acoustic 
Calibration EQ.

Again, try to be as quiet as possible while this 
is happening. It may take 3 to 7 minutes.

• If you selected a 

Point setup (in step 2), you will be asked to 
place the mic at the 2nd and 3rd reference 
points before finally placing it at your main 
listening position.

completed and the Advanced MCACC menu 
reappears automatically.
The settings made in the Auto MCACC Setup 
should give you excellent surround sound from 
your system, but it is also possible to adjust 
these settings manually using the 

MCACC setup menu (starting below) or 
Manual SP Setup menu (starting on 
page 94).

1

You can also choose to view the settings by 
selecting individual parameters from the 
MCACC Data Check screen:

•

Speaker Setting – The size and number of 
speakers you’ve connected (see page 95 
for more on this)

•

Channel Level – The overall balance of 
your speaker system (see page 83 or 96 for 
more on this)

•

Speaker Distance – The distance of your 
speakers from the listening position (see 
page 83 or 97 for more on this)

2

•

Standing Wave – Filter settings to control 
lower ‘boomy’ frequencies (see page 85 for 
more on this)

•

Acoustic Cal EQ – Adjustments to the 
frequency balance of your speaker system 
based on the acoustic characteristics of 
your room (see page 85 for more on this)

Press 

RETURN after you have finished checking 

each screen. When you’re finished, select 
RETURN to go back to the HOME MENU.

Be sure to disconnect the microphone from 
this receiver upon completion of the Auto 
MCACC Setup.

1 • Depending on the characteristics of your room, sometimes identical speakers with cone sizes of around 12 cm (5 

inches) will end up with different size settings. You can correct the setting manually using the 

on page 94.
• The subwoofer distance setting may be farther than the actual distance from the listening position. This setting 
should be accurate (taking delay and room characteristics into account) and generally does not need to be changed.
• If Auto MCACC Setup measurement results are incorrect due to the interaction of the speakers and viewing 
environment, we recommend adjusting the settings manually.

2 Since the distance measurements have been set according to the sound characteristics of your speakers, there are 

cases where (for optimal surround sound) the actual distance may differ from the speaker distance setting.

VSX-1019_KU.book  Page 81  Thursday, January 8, 2009  12:01 PM