Pioneer A9 ユーザーズマニュアル
Additional information
07
26
En
XM radio messages
Specifications
Amplifier section
Power output specification is for when power
supply is 120 V.
Power output specification is for when power
supply is 120 V.
•
Continuous power output (both channels
driven at 20 Hz to 20 kHz)**
THD 0.2 %, 4
Ω
. . . . . . . . . . . . . . . . . 70 W + 70 W
THD 0.2 %, 8
Ω
. . . . . . . . . . . . . . . . . 55 W + 55 W
•
FTC Continuous power output (both
channels driven at 1 kHz)
THD 1.0 %, 4
Ω
. . . . . . . . . . . . . . . . . 65 W + 65 W
THD 1.0 %, 8
Ω
. . . . . . . . . . . . . . . . . 55 W + 55 W
•
Total harmonic distortion**
20 Hz to 20 kHz, 25 W, 8
Ω
. . . . . . . . . . . . 0.05 %*
* Measured with DIRECT button switched on.
** Measured by Audio Spectrum Analyzer
** Measured by Audio Spectrum Analyzer
Can’t operate the remote
control.
control.
• Replace the battery (refer to page 7).
• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel
(refer to page 13).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel
(refer to page 13).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off.
• Press
DIMMER on the remote repeatedly to return to the default.
Problem
Remedy
Message
Cause
Action
ANTENNA
The XM antenna is not connected.
Check that the XM antenna cable is attached
securely.
securely.
ANT ERR
A short-circuit occurring in the antenna or
surrounding antenna cable.
surrounding antenna cable.
Make sure that there is nothing unusual with
the antenna or antenna cable. Switch the
power off then back on again.
the antenna or antenna cable. Switch the
power off then back on again.
UPDATING
The radio is being updated with the latest
encryption code.
encryption code.
Wait until the encryption code has been
updated. Channels 00 and 01 should function
normally.
updated. Channels 00 and 01 should function
normally.
NO SIGNAL
The XM signal is too weak at the current
location.
location.
n/a
LOADING
The receiver is acquiring audio or program
information.
information.
Wait until the information has been received.
OFF AIR
The channel currently selected has stopped
broadcasting.
broadcasting.
Select another channel.
CH– – –
You have selected a channel that does not
exist, or that you have not subscribed to.
exist, or that you have not subscribed to.
The receiver will automatically switch to
channel 001 (or the last selected channel).
channel 001 (or the last selected channel).
There is no artist name/feature, song/
program title, or channel category associated
with the channel at this time.
program title, or channel category associated
with the channel at this time.
No action needed.
A9_KU.book 26 ページ ２００６年１１月６日 月曜日 午後３時３４分