Pyramid Car Audio XPA-200 ユーザーズマニュアル

3-PYRAMID XPA-100/XPA-200/XPA-300 Amplifier Owner’s Manual

PYRAMID XPA-100/XPA-200/XPA-300 Amplifier Owner’s Manual-4

After making all other connections, set the POWER switch 

to OFF position. Then connect the power cord to a standard 

AC outlet.

This amplifier is designed to accept standard rack mounting 

installations. Two slots on each end of the front panel make 

it suitable for such an installation.

Tightly secure four mounting screws (not supplied) through 

these fours slots and into your standard electronics equipment 

rack.

1. Turn on the audio input source equipment which is 

connected to the amplifier INPUT jacks.

2. Set the amplifier’s Channel 1 and Channel 2 output level 

gain controls to the minimum level settings.

3. Push in the power switch to turn the amplifier on.

The meter pointer position indicates the amplifier output 

power. For ease of reading in dark environments, the meter 

is illuminated.

This amplifier can operate in a mono bridged output mode, if 

your speakers can handle the following power output levels:

XPA-100:

   1000 watts

XPA-200:

   1600 watts

XPA-300:

   2000 watts

As shown in the diagram below, connect the speaker's positive 

(+) to the amplifier's red speakers left (1/2) terminals and 

negative (-) to red speakers right (1/2) terminals.

The speaker right (+) on the amplifier is used as a negative (-) 

terminal for a bridged connection.

Rotate output level gain clockwise to increase, or counter-

clockwise to decrease the output power. To get the best 

performance with the least sound distortion, always adjust 

the output level gain so the meter's pointer does not 

continuously exceed the extreme right of the meter's scale.  

Special clip circuitry incorporated into your PYRAMID XPA 

amplifier’s design protects the amplifier and speaker system 

from being damaged from overdriving power. 

Under normal conditions, the amplifier’s clip indicator will 

flicker as the output power momentarily exceeds the level 

as set by the output level gain selector. 

However, under excessive output conditions, the protect 

indicator lights remain on continuously, alerting you that 

the special clip circuitry has become active. When this 

occurs, you should simply reduce the output power level 

by rotating the Master Volume control counterclockwise.