Link electronic DigiFlex 1151 プリント
1000 SERIES DIGIFLEX
Mounting Frame Options
1000 - Single Power Supply, Holds 11 Modules
1000/2 - Dual Power Supply, Holds 10 Modules
7200 - Mounting Frame, Holds 1 Module
1000/2 - Dual Power Supply, Holds 10 Modules
7200 - Mounting Frame, Holds 1 Module
LINK ELECTRONICS, INC.
ANALOG WHITE CLIP VIDEO DA 1 X 8
DigiFlex 1151
FEATURES
White Clip
Op Amp. Technology
Eight Outputs, 7 Looping
DC Coupled
±3dB Gain
100 MHZ Bandwidth
Diff. Gain and Phase 0.1
The DigiFlex 1151 is a state-of-the-art analog video
distribution amplifier with cable equalization and
white clip. The 1151 provides high-performance
analog video distribution in the LINK DigiFlex 1000
Frame. The advantage is obvious: both analog
and digital distribution amplifiers can operate side-
by-side in a single frame!
distribution amplifier with cable equalization and
white clip. The 1151 provides high-performance
analog video distribution in the LINK DigiFlex 1000
Frame. The advantage is obvious: both analog
and digital distribution amplifiers can operate side-
by-side in a single frame!
Utilizing the latest CMF Op-Amp technology, the
1151 combines wide bandwidth, low noise, and low
power consumption. The video path is truly
transparent, with differential phase and gain errors
of <0.1°
1151 combines wide bandwidth, low noise, and low
power consumption. The video path is truly
transparent, with differential phase and gain errors
of <0.1°
and <0.1%, respectively. Video signal-to-
noise ratio exceeds 65dB. Frequency response is
exceptionally flat beyond 40MHz and features a
gentle roll-off to -3dB at 100MHz–perfect for analog
HDTV. Eight outputs are provided on it’s
companion rear cell, 1011. The 1011 has only 7
outputs if the input is specified looping.
exceptionally flat beyond 40MHz and features a
gentle roll-off to -3dB at 100MHz–perfect for analog
HDTV. Eight outputs are provided on it’s
companion rear cell, 1011. The 1011 has only 7
outputs if the input is specified looping.
DC-coupled differential input is a standard feature,
providing high common-mode rejection. Cable
equalization is adjustable from the front card edge
and can compensate for loss in coax cable up to
1000 feet of Belden 8281. Clamp is referenced to
back porch. White clip is adjustable from the front
card edge with a range of 100 IRE units ±30 IRE
units.
providing high common-mode rejection. Cable
equalization is adjustable from the front card edge
and can compensate for loss in coax cable up to
1000 feet of Belden 8281. Clamp is referenced to
back porch. White clip is adjustable from the front
card edge with a range of 100 IRE units ±30 IRE
units.
The attention to detail in the design of the 1151
extends to the power supply, which features a
simple switching regulator. While slightly more
complex than a linear supply, this offers the highest
possible efficiency. In addition, this unit is backed
by a ten-year warranty including parts and labor
extends to the power supply, which features a
simple switching regulator. While slightly more
complex than a linear supply, this offers the highest
possible efficiency. In addition, this unit is backed
by a ten-year warranty including parts and labor
Two convenient mounting frames are available for
the DigiFlex series products, 1000 and 7200.
the DigiFlex series products, 1000 and 7200.
LINK
ELECTRONICS, INC. 2137 Rust Avenue Cape Girardeau, MO 63703-7668
Phone 573 334 4433 FAX 573 334 9255
MADE IN THE USA