Marantz Model SC-11S1 ユーザーズマニュアル

ページ / 37
19
ENGLISH
CONNECTIONS
SPEAKER POSITIONING FOR SUPER 
AUDIO MULTI-CHANNEL SOUND
In order to enjoy Super Audio CD multi-channel sound with 
the best possible acoustics, it is recommended to position 
speakers as specified in ITU-R BS.775-1 of the International 
Telecommunication Union (ITU). Super Audio CD multi-channel 
discs are recorded and mixed so as to achieve the optimum 
effect with a speaker system laid out as specified in ITU-R 
BS.775-1.
•  With Super Audio CD multi-channel discs, the music signals 
are basically recorded using 5 channels (3 - 6 channels 
sometimes), but in some cases, LFE (for subwoofer) is 
recorded as a sixth channel. Each disc indicates how many 
channels have been recorded on it.
•  The basic layout is 3 speakers in the front and 2 in the back 
since multi-channel discs usually have 5 channels. The 2 
front, 1 center and 2 surround (rear) speakers should be set 
in a circle around the listening point as shown below. If using 
speakers of differing sizes, adjust volume balance from the 
amplifier.
•  The location of the subwoofer in the figure is just for 
explanatory purposes. It can be located anywhere in the 
room. For connection and positioning instructions, see the 
instruction manual that came with the subwoofer.
 ITU (International Telecommunication Union)
The ITU is a special organization of the United Nations.  It 
consists of a number of organs, one of which is the Radio 
Broadcasting Section.
ITU-R BS in the recommendation which consists of standards 
relating to broadcasting (audio) operations, one of which is the 
ITU-R BS.775-1 which governs “multi-channel stereo sound 
systems.”
Center 
speaker
Rear speaker
(Right Surround)
Sub-woofer
Front speaker
(Left)
Rear speaker
(Left Surround)
Front speaker
(Right)
Reference listening 
position
approx. 110°
approx. 110°
60°
CONNECTING THE  POWER  SUPPLY
1.
  Plug the power cable into AC IN jack on the back panel.
2.
  Turn on the power switch of the audio unit (amplifier, etc.) 
that is connected with this unit. Set the selector on the 
connected unit to this unit.
3.
  Plug the power cable into an AC outlet.
SC-11S1_UN_01_Eng.indd   19
SC-11S1_UN_01_Eng.indd   19
07.9.14   2:40:00 PM
07.9.14   2:40:00 PM