Marantz PM6002 ユーザーズマニュアル

ENGLISH

CONNECTION OF SPEAKER SYSTEMS

This unit is equipped with two sets of SPEAKER SYSTEM terminals––SYSTEM 1 terminals and SYSTEM
2 terminals. Usually connect your speaker system to the SYSTEM 1 terminals.

• The speakers in the speaker system should have an impedance between 8 and 16 ohms. If speakers with

an impedance of less than 8 ohms are connected, the protection circuitry may be activated during play.

• Connect the Right channel speaker to the R terminals, and the Left channel speaker to the L terminals.

• The output terminals have positive (+: Red) and negative

(–: Black) polarity, and each speaker also has the same polarity (+ and –). When connecting the speaker,

be sure to connect the terminals with the same polarity (+ with +, – with –).

SYSTEM2

SYSTEM 1

4 –16 OHMS

–16 OHMS

SYSTEM 2

4 –16 OHMS

–16 OHMS

SYSTEM 1

SYSTEM 1+ 2 :

2 :

8 –16 OHMS

–16 OHMS

SYSTEM1

PHONO

GND

OUT

SPEAKER SYSTEMS

(CD-R

CD-R)

(MD

MD / TAPE

TAPE)

AUX

AUX / DVD

DVD

TUNER

RECORDER 1

RECORDER 2

CONNECTIONS

WIRING SPEAKER CABLE

• Be careful not to short circuit in wiring speaker

cables.

• Peel off the corting of speaker cable as shown

below.

Approx. 1 cm

Cut the corting of
cable.

Peel off the edge
of cable.

Twist conductors.

• Wiring with speaker cable.

Turn counter-
clockwise to
loosen.

Insert conductor
of cable.

Turn clockwise to
tighten.

Your speaker system must satisfy the below
conditions. If it does not, the PM6002’s protective
circuit will active, whereby preventing proper
playback. In some cases, the amplifier and speakers
may be damaged.

• If using 1 set of speakers, total speaker

impedance must be 4 ohms or more.

• If using 2 sets of speakers, total speaker

impedance must be 8 ohms or more.

PM6002N_01_ENG.indd 9

07.7.18 9:56:14 AM