ONKYO A-9355 ユーザーズマニュアル

11

The A-9355/A-9155’s PHONO input jacks are for use 
with moving-magnet (MM) type cartridges.
Use an analog audio cable to connect the 
A-9355/A-9155’s PHONO L/R jacks to the audio out-
put jacks on the turntable, as shown.
If your amplifier has shorting pin plugs, remove the 
shorting pin plugs before connecting your turntable.

Notes:
• If the turntable has a ground wire, connect it to 

A-9355/A-9155’s GND terminal. With some turnta-
bles, connecting the ground wire may cause hum, in 
which case it should be disconnected.

• If the turntable has a moving-coil (MC) type car-

tridge, you’ll need a commercially available MC 
phono preamp. In this case, connect the turntable to 
the phono preamp’s input, and connect the phono 
preamp’s output to the A-9355/A-9155’s PHONO 
L/R jacks.

Use an analog audio cable to connect the 
A-9355/A-9155’s CD L/R jacks to the analog audio out-
put jacks on the CD player, as shown.

• Always refer to the instructions that came with the 

component that you are connecting.

• Do not plug in the power cord until all connec-

tions have been properly made.

• Do not bind audio cables with power cords and 

speaker cables. Doing so may adversely affect the 
sound quality.

• To prevent interference, keep power cords and 

speaker cables away from the tuner’s antenna.

• Red connectors are used for the right channel, and 

white connectors are used for the left channel.

• Push each plug in all the way to make a good con-

nection (loose connections can cause noise or 
malfunctions).

Ground wire