ONKYO 9555 ユーザーズマニュアル

17

Enjoying Audio Sources—Continued

You can use the A-9755 as power amplifier with a sepa-
rate preamp. See page 13 for connection information.

Notes:
• You can record on a recorder that’s connected to the 

MD OUT or TAPE OUT L/R jacks.

• The tone controls have no effect on the signal being 

recorded.

• When using the A-9755 as a power amplifier (MAIN 

IN function), recording is not possible.

Press the [POWER AMP DIRECT 
(MAIN IN)] button for 3 seconds 
until the MAIN IN indicator lights up.
The MAIN IN function comes on and 
the MAIN IN indicator lights up.

While the MAIN IN function is on, 
only audio from components con-
nected to the preamp can be output. 

To turn the MAIN IN function off, 
press the [POWER AMP DIRECT 
(MAIN IN)] button for 3 seconds until 
the MAIN IN indicator goes off.
Notes:
• Do not connect a component that 

does not have an output volume con-
trol to the MAIN IN jacks and use the 
MAIN IN function, because the 
sound will be output at maximum 
volume and may damage the A-9755 
and your speakers.

• While the MAIN IN function is on, 

the A-9755’s Volume control has no 
effect. Before you turn off the 
MAIN IN function, make sure that 
the Volume control is not turned up 
high, to prevent any loud surprises.

• While the MAIN IN function is on, 

the following A-9755 functions are 
disabled:
- Volume control
- Input selector
- Remote control operation
-  

function

- LOUDNESS control
- Recording
- Muting
Operate the connected preamp for 
some of these functions including 
controlling volume, selecting input, 
and muting. The [STANDBY] and 
[ON] buttons on the remote control-
ler will work even when the MAIN 
IN function is on.

Prepare the recorder:
• Set the recorder so that it’s ready for 

recording.

• If necessary, adjust the recording 

level on the recorder.

• See the recorder’s manual for more 

information.

Note:
If you select another input source dur-
ing recording, the newly selected input 
source will be recorded.