MB Quart ALX3PS ユーザーズマニュアル

3. Use a drywall saw or other appropriate tool to carefully cut out the speaker holes. The cut-out is the
    exact size required for the speaker. You also can go as much as 1/4” over this size as “Mistake Room”.
4. Connect the speaker wires (18 gauge wire not supplied) to the speakers as shown in DIAGRAM 2.
    (Be sure to get the + and - polarity correct)
5. Place the speaker into the speaker opening and using a # 2 phillips screw driver, turn the Dog-Ear 
    fastening screws clockwise (be sure to support the weight of the speaker until all Doq-Ear screws
    are securely tightened).
    The Dog-Ear Clamps will rotate away from the speaker enclosure and begin to tighten against the 
    mounting surface to secure the speaker as shown in DIAGRAM 3.
6. Carefully route the speaker wires to the amplifier or other power source. Be sure to avoid moving parts,
    heat producing items and water exposure.

To amplifier or 
surround sound 
receiver 8-Ohms

To amplifier or 
surround sound 
receiver 8Ohms

To amplifier or 
surround sound 
receiver 4-Ohms

To amplifier or 
surround sound 
receiver 4-Ohms

Use this wiring configuration
to combine left and right audio
channels to power a single
speaker in locations where  
right and left speakers are 
unsuitable.

   2 CHANNEL INPUT
DUAL-MONO SPEAKER

SINGLE INPUT SPEAKER

OR