JVC RV-NB20W ユーザーズマニュアル
9
Listening to the radio
You can listen to FM and AM stations. Stations can be tuned in manually, automatically, or from preset memory storage.
Before listening to the radio, fully extend the FM telescopic antenna.
1. Press FM/AM repeatedly to select either
FM or AM.
Each time you press FM/AM, the band changes between FM
and AM.
The system tunes in to the last tuned station. The following
information appears on the display.
– When “Manual Tuning” or “Auto Tuning” was used to tune
Each time you press FM/AM, the band changes between FM
and AM.
The system tunes in to the last tuned station. The following
information appears on the display.
– When “Manual Tuning” or “Auto Tuning” was used to tune
in to the last tuned station (see below), the band frequency
appears.
appears.
– When “Preset Tuning” was used to tune in to the last tuned
station (see the right column), the preset number (displayed
as “P-XX” on the display) and then the band frequency
appear.
as “P-XX” on the display) and then the band frequency
appear.
2. Select a station using one of the following
methods.
• When you tune in to an FM stereo broadcast, the STEREO
• When you tune in to an FM stereo broadcast, the STEREO
indicator lights up and you can hear stereo effect.
If an FM stereo broadcast is hard to receive or
noisy,
If an FM stereo broadcast is hard to receive or
noisy,
press FM MODE. The MONO indicator lights up and
the sound becomes monaural, but the reception improves.
When you tune in to another station, the MONO indicator
goes off and stereo effect restores automatically.
When you tune in to another station, the MONO indicator
goes off and stereo effect restores automatically.
Note: AM broadcasts are monaural.
Manual Tuning
Press 4 or x repeatedly to move from frequency to
frequency until you find the station you want.
Press 4 or x repeatedly to move from frequency to
frequency until you find the station you want.
OR
Auto Tuning
Press and hold 4 or x for one second or more.
The frequency changes automatically until a station frequency
is found.
Press and hold 4 or x for one second or more.
The frequency changes automatically until a station frequency
is found.
OR
Preset Tuning (possible only after presetting stations)
Select the desired preset number using PRESET TUNING on
the system or the number buttons on the remote control. The
preset number and then the band frequency appear on the
display.
Select the desired preset number using PRESET TUNING on
the system or the number buttons on the remote control. The
preset number and then the band frequency appear on the
display.
PRESET TUNING button:
Each time you press the button, the
preset number increases.
preset number increases.
Number buttons:
To select P-5, press 5.
To select P-15, press +10 then 5.
To select P-20, press +10 once then
press 10.
To select P-15, press +10 then 5.
To select P-20, press +10 once then
press 10.
Notice: To adjust the reception condition
For FM:
Adjust the FM telescopic antenna’s length, angle and
direction until the best reception is obtained.
direction until the best reception is obtained.
For AM:
Change the direction of the system to obtain the best
reception.
Placing the system near the window, for example, will
improve AM reception.
reception.
Placing the system near the window, for example, will
improve AM reception.
FM/AM
PRESET TUNING
4
x
FM/AM
4
x
Number buttons
FM MODE
SET
FM MODE
Tuning in to a station
(After one second)
RV-NB20[J].book Page 9 Tuesday, August 22, 2006 3:28 PM