Diamond D363.5 ユーザーズマニュアル

©2008 Diamond Audio Technologies. All rights reserved.

 

When flush or surface mounting tweeters, make sure the 
desired location can accommodate the hole size and depth 
required. Mount the cup using provided hardware (flush mount 
illustration shown on right.) Mount surface cup at desired angle with 
provided screws in tweeter mounting kit. Snake speaker wires through tweeter 
cup, connect tweeter to wires, and snap tweeter into cup by aligning the notches. 
Be careful not to push on the center of the tweeter grill.  
 

Each D3 component set comes with a pair of model specific programmable crossovers. Under the cover 
there is a jumper marked “TWEETER” + 2dB, 0 or - 2dB. Tweeter attenuation can be achieved by moving 
the jumper to the appropriate position. The 0dB  position has no attenuation effect on the tweeter.

Each D3 component crossover has a third set of outputs marked “RAF”. This stands for Rear Acoustic 
Fill. This output can be used to power an additional speaker off the same channel without affecting 
the impedance load on the source unit. This output provides 15-20% of the total power to the extra 
speaker and is unfiltered or full range.