Vienna Acoustics BERG ユーザーズマニュアル
attach the speaker to the bracket by tightening
completely the upper conical tipped bolt with the
hexagonal tool (Allen wrench/ key). Please make
sure that you use the same conically milled point
on both, lower and upper, inlays.
ATTENTION:
For safety reasons it is recommended that all
connection bolts be tightened every six months.
B. Free-standing application:
Connecting the speakers to the aluminium stands
(please see drawing):
ATTENTION:
Usually, you want the tweeters to look in two
different directions. In this case, you have to act
as follows:
1. Please put on the enclosed gloves to avoid
fingerprints.
2. Put your pair of speakers in front of you in a
way that the tweeters are to the inside.
3. Pull out the inlay of each speaker. Since they
are attached with magnets, they simply pull off.
completely the upper conical tipped bolt with the
hexagonal tool (Allen wrench/ key). Please make
sure that you use the same conically milled point
on both, lower and upper, inlays.
ATTENTION:
For safety reasons it is recommended that all
connection bolts be tightened every six months.
B. Free-standing application:
Connecting the speakers to the aluminium stands
(please see drawing):
ATTENTION:
Usually, you want the tweeters to look in two
different directions. In this case, you have to act
as follows:
1. Please put on the enclosed gloves to avoid
fingerprints.
2. Put your pair of speakers in front of you in a
way that the tweeters are to the inside.
3. Pull out the inlay of each speaker. Since they
are attached with magnets, they simply pull off.