Sony STRDH720 ユーザーズマニュアル

D:\NORM'S JOB\SO0135\4262412121_GB\GB07ADD_STR-DH720-CEL.fm

STR-DH720

4-262-412-12(1)

• The data stored in the USB device may 

have been corrupted.

• The character codes that can be displayed 

by this receiver are as follows:
– Upper cases (A to Z)
– Numbers (0 to 9)
– Symbols (’ < > * + , – . / [ \ ] _ `)

 

Other characters may not be displayed 
correctly.

• Turn off the receiver, then disconnect the 

USB device. Turn on the receiver again 
and reconnect the USB device.

• Connect the supported USB device 

 

• The USB device does not work properly. 

Refer to the USB device operating 
instruction on how to deal with this 
problem.

• Turn off the receiver and reconnect the 

USB device, then turn on the receiver.

• Connect the supported USB device 

 

• Press N to start playback.

• MP3 files in MP3 PRO format cannot be 

played back.

• The audio file is a multiple track audio file.
• Some AAC files may not be played back 

correctly.

• WMA files in Windows Media Audio 

Lossless and Professional format cannot 
be played back.

• USB device formatted with file systems 

other than FAT16 or FAT32 are 
unsupported.*

• If you use partitioned USB device, only 

audio files on the first partition can be 
played back.

• Playback is possible up to 8 levels 

(including “ROOT” folder).

• The number of folders has exceeded 100 

(including “ROOT” folder).

• The number of files in a folder has 

exceeded 100.

• Files that are encrypted or protected by 

passwords, etc. cannot be played back.

* This unit supports FAT16 and FAT32, but some 

USB device may not support all of these FAT. 

 

For details, refer to the operating instruction of 
each USB device or contact the manufacturer.

• Point the remote control at the remote 

control sensor on the receiver.

• Remove any obstacles in the path between 

the remote control and the receiver.

• Replace all the batteries in the remote 

control with new ones, if they are weak.

• Make sure you select the correct input on 

the remote control.

• Check the HDMI connection (page 23).
• Make sure “Ctrl for HDMI” is set to “ON” 

in HDMI Settings menu.

• Make sure the connected equipment is 

compatible with the Control for HDMI 
function.

• Check the Control for HDMI settings on 

the connected equipment. Refer to the 
operating instructions of the connected 
equipment.

• When “Ctrl for HDMI” is set to “OFF”, 

the “BRAVIA” Sync does not work 
properly, even if the equipment is 
connected to the HDMI IN jack.