Kenwood TH-K2ET ユーザーズマニュアル
40
3 Press [MENU] (1 s).
•
When the transceiver receives a signal, scan starts.
The decimal point blinks during scan.
The decimal point blinks during scan.
•
While the transceiver is receiving a signal during Tone
Freq. ID Scan, the signal is emitted from the speaker.
Freq. ID Scan, the signal is emitted from the speaker.
•
To reverse the scan direction, turn the Tuning control.
•
To quit the function, press [PTT].
•
When the tone frequency is identified, a beep sounds
and the identified frequency blinks.
and the identified frequency blinks.
4 Press [MENU] to program the identified frequency in
place of the current tone frequency.
•
Press any key other than [MENU], [LAMP], and
[MONI/SQL] if you do not want to program the
identified frequency.
[MONI/SQL] if you do not want to program the
identified frequency.
•
Turn the Tuning control while the identified frequency
is blinking to resume scanning.
is blinking to resume scanning.
Note: Some repeaters do not re-transmit the access tone in the
downlink signal. In this case, check the other station’s uplink signal
to detect the repeater access tone.
downlink signal. In this case, check the other station’s uplink signal
to detect the repeater access tone.