JVC SP-UXL36V ユーザーズマニュアル
– 24 –
English
Recording
Recording on a Tape
On the unit ONLY:
1
Put a recordable cassette in with the exposed
part of the tape down.
part of the tape down.
2
Close the cassette holder gently and check the
recording direction for the tape.
recording direction for the tape.
• If the tape direction is not correct, press TAPE
2 3
twice then
7 to change the tape direction.
• If you want to record on both sides of a tape, see “To
record on both sides—Reverse Mode.”
3
Start playing the source—FM, AM or
auxiliary equipment connected to AUX jacks.
auxiliary equipment connected to AUX jacks.
• When the source is CD, see “CD Direct Recording” on
page 25.
4
Press REC (recording).
The REC (recording) indicator lights up on
the display and recording starts.
the display and recording starts.
To stop recording, press
7.
The tape stops after 4 seconds.
To remove the cassette, press
0 PUSH OPEN on the unit.
To record on both sides—Reverse Mode
Press REV.MODE (reverse mode) until
the
the
indicator is lit.
• When using the Reverse Mode for
recording, start recording in the
forward (
forward (
3) direction first.
Otherwise, recording will stop when
recording is done only on one side
(reverse) of the tape.
recording is done only on one side
(reverse) of the tape.
IMPORTANT:
• It may be unlawful to record or play back copyrighted
material without the consent of the copyright owner.
• The recording level is automatically set correctly, so it is
not affected by the other sound settings. Thus, during
recording you can adjust the sound you are actually
listening to without affecting the recording level.
recording you can adjust the sound you are actually
listening to without affecting the recording level.
• If recordings you have made have excessive noise or static,
the unit may be too close to a TV. Increase the distance
between the TV and the unit.
between the TV and the unit.
• You can use type I tape for recording.
To protect your recording
Cassettes have two small tabs
on the back to protect from
unexpected erasure or re-
recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
on the back to protect from
unexpected erasure or re-
recording.
To protect your recording,
remove these tabs.
To re-record on a protected tape, cover the holes with
adhesive tape.
To keep the best recording and playback sound quality
If the heads, capstans, and pinch rollers of the cassette decks
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
become dirty, the following will occur:
• Impaired sound quality
• Discontinuous sound
• Fading
• Incomplete erasure
• Difficulty in recording
To clean the heads, capstans, and pinch rollers
Use a cotton swab moistened with alcohol.
Use a cotton swab moistened with alcohol.
To demagnetize the heads
Turn off the unit, and use a head demagnetizer (available at
electronics and audio shops).
Turn off the unit, and use a head demagnetizer (available at
electronics and audio shops).
At the start and end of cassette tapes
There is leader tape which cannot be recorded onto. Thus, when
recording CDs or radio broadcasts, wind the leader tape first to
ensure that the recording will be made without any music part lost.
recording CDs or radio broadcasts, wind the leader tape first to
ensure that the recording will be made without any music part lost.
Heads
Capstans
Pinch Rollers
REC
REV.MODE
REV. MODE
On the unit
(only for UX-L36V)
Continued
EN24-32_UX-L46&36[US&UJ]f
28/5/2002, 4:00 PM
24