JVC SP-UXG68 ユーザーズマニュアル

• Make sure the antenna conductors do not touch any other 

terminals, connecting cords or the power cord. Also, keep 
the antennas away from metallic parts of the System, 
connecting cords and the AC power cord. This could cause 
poor reception.

• Use only speakers with the same speaker impedance as 

indicated by the speaker terminals on the rear of the System.

• The speakers are magnetically shielded to avoid color 

distortions on TVs. However, if not installed properly, it 
may cause color distortions. So, pay attention to the 
following when installing the speakers.
– When placing the speakers near a TV set, turn off the 

TV’s main power switch or unplug it before installing the 
speakers.
Then wait at least 30 minutes before turning on the TV’s 
main power switch again.

– Some TVs may still be affected even though you have 

followed the above instructions. If this happens, move 
the speakers away from the TV.

Listening to the Radio:
• If you store a new station into an occupied preset number, 

the previously stored station in that number will be erased.

• When you unplug the AC power cord or if a power failure 

occurs, the preset stations will be erased in a few days. If 
this happens, preset the stations again.

Playing Back a Disc/File:
• When you change the source to DVD/CD or USB 

MEMORY, it may take a while to activate the source.

• The following functions cannot be used for the files in the 

USB mass storage class device:
– Selecting the View Angle (page 17)

– Special Effect Playback (page 18)
– Program Play (page 19)
– A-B Repeat (page 21)

– Time Search (page 24)

• On some DVD, SVCD, or VCD discs, the actual operations 

may be different from what is explained in this manual, due 
to the programming and disc structure; such differences are 
not a malfunction of this System.

• If you playback a DVD Video for more than 10 hours, “_” 

appears instead of the hour digits.

• Some DVD Audio discs prohibit downmix. When you 

playback such a disc, “LR ONLY” appears on the display 
and the System plays back the left front and right front 
signals.

• When playing back a DVD Audio disc recorded in MLP 

(Meridian Lossless Packing; a lossless audio compression 
system that can completely recreate the PCM signal), the 
signals are recognized as the linear PCM signals, however, 
no indicator lights up on the display.

• This System can recognize up to 4 000 tracks in a disc. 

Also, the System can recognize up to 150 tracks per group 
and up to 99 groups in a disc.
– If there are any unplayable files in a folder, those files are 

also counted in the total file number.

– Playable files which do not belong to any groups are 

handled as group 1.

• For playback of files in the USB mass storage class 

device...
– While the System is reading a disc, changing the source 

to USB MEMORY may cause the System to continue 
playback the DVD/CD source. In this case, press 7 on 
the main unit to reactivate the USB source.

– When connecting a USB mass storage class device, refer 

also to its manual.

– Connect one USB mass storage class device to the 

System at a time. Do not use a USB hub.

– You cannot charge any USB device through the USB 

MEMORY jack of this System.

– While playing back a file in a USB mass storage class 

device, do not disconnect the device. It may cause a 
malfunction of both the System and the device.

– JVC bears no responsibility for any loss of data in the 

USB mass storage class device while using this System.

– When connecting with a USB cable, use the cable whose 

length is less than 1 m.

– This System is compatible with the USB Full-Speed (not 

compatible with the USB 1.1).

– You can playback the following types of files in a USB 

mass storage class device (maximum data transfer rate: 
2 Mbps):
– Music: MP3, WMA, WAV

– Picture: JPEG

– Movie: MPEG-1, MPEG-2, ASF, DivX (maximum 

frame rate of 30 fps for progressive)

– You cannot playback a file larger than 2 Gigabyte.
– When playing a file which has a large transfer rate, 

frames or sounds may be dropped during playback.

– This System cannot recognize a USB mass storage class 

device whose rating is other than 5 V and does not 
exceed 500 mA.

– This System may not playback some USB mass storage 

class devices and does not support DRM (Digital Rights 
Management).

– This System may not playback some files even though 

their formats are listed above.

– It will take some time to start up a Digital Audio Player 

(DAP) larger than 1 Gigabyte.

• For DVD-VR playback...

– This System can play only a disc of UDF-Bridge format.
– For details about DVD-VR format and play list, refer to 

the manual of the recording equipment.

– You cannot use reverse slow motion, Program Play, or 

Random Play.

UX-G68[U].book  Page 37  Tuesday, December 5, 2006  4:03 PM