JVC UX-G50 ユーザーズマニュアル

ページ / 57
 
G-2
 
For the main unit:
 
Declaration of Conformity
Model Number:
UX-G50
Trade Name:
JVC
Responsible Party: JVC Americas Corp.
Address:
1700 Valley Road, Wayne
New Jersey 07470
Telephone Number: 973-317-5000
This device complies with Part 15 of FCC Rules. 
Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, 
and (2) this device must accept any interference 
received, including interference that may cause 
undesired operation.
 
Note to CATV system installer:
 
This reminder is provided to call the CATV system 
installer’s attention to section 820-40 of the NEC 
which provides guidelines for proper grounding and, 
in particular, specifies that the cable ground shall be 
connected to the grounding system of the building, 
as close to the point of cable entry as practical.
 
For Canada/pour le Canada
 
THIS DIGITAL APPARATUS DOES NOT EXCEED 
THE CLASS B LIMITS FOR RADIO NOISE 
EMISSIONS FROM DIGITAL APPARATUS AS SET 
OUT IN THE INTERFERENCE-CAUSING 
EQUIPMENT STANDARD ENTITLED “DIGITAL 
APPARATUS,” ICES-003 OF THE DEPARTMENT 
OF COMMUNICATIONS.
CET APPAREIL NUMERIQUE RESPECTE LES 
LIMITES DE BRUITS RADIOELECTRIQUES 
APPLICABLES AUX APPAREILS NUMIRIQUES DE 
CLASSE B PRESCRITES DANS LA NORME SUR LE 
MATERIEL BROUILLEUR; “APPAREILS 
NUMERIQUES”, NMB-003 EDICTEE PAR LE 
MINISTRE DES COMMUNICATIONS.
 
Caution: Proper Ventilation
 
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:
1. Front: No obstructions and open spacing.
2. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below.
3. Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm 
(3-
 
15
 
/
 
16
 
") or more.
 
Attention: Aération correcte
 
Pour prévenir tout risque de décharge électrique ou d’incendie et éviter toute détérioration, installez l’appareil de la manière 
suivante:
1. Avant: Bien dégagé de tout objet.
2. Côtés/dessus/dessous: Assurez-vous que rien ne bloque les espaces indiqués sur le schéma ci-dessous.
3. Dessous: Posez l’appareil sur une surface plane et horizontale. Veillez à ce que sa ventilation correcte puisse se faire en le 
plaçant sur un support d’au moins dix centimètres de hauteur.
*
 
About the cooling fan
 
A cooling fan is mounted on the rear panel of the unit to prevent abnormal temperature inside the unit, thus assuring normal 
operation of the unit. The cooling fan automatically starts rotating to intake external cool air when the volume is increased 
up to more than a certain level.
*
 
À propos du ventilateur de refroidissement
 
Un ventilateur de refroidissement se trouve sur le panneau arrière de l’appareil afin d’éviter la création d’une température 
anormale à l’intérieur de l’appareil et permettre ainsi un fonctionnement normal de l’appareil. Le ventilateur de 
refroidissement commence à tourner et à aspirer de l’air frais automatiquement quand le volume est augmenté au-dessus 
d’un certain niveau.
10 cm
15 cm
1 cm
15 cm
15 cm
1 cm
15 cm
15 cm
Front
Face
Side
Côté
SP-UXG50
CA-UXG50
SP-UXG50
CA-UXG50
 
UX-G50[C].BOOK  Page 2  Friday, February 10, 2006  3:04 PM