JVC SP-UXQD9S 取り扱いマニュアル
Introduction
11
Connections
1
Set up the AM antenna (supplied).
2
Connect the antenna cord.
3
Turn the AM loop antenna to find
the best position for radio
reception.
Place the AM loop antenna as far
from the main unit as possible.
• Do not place the AM loop antenna on a
metallic table or close to a TV, computer, or
other electric appliances. Doing so may
affect radio reception.
other electric appliances. Doing so may
affect radio reception.
■When radio reception with the supplied AM
loop antenna is poor
Connect all necessary parts before connecting the power plug.
Connecting the Antennas
Connecting the AM antenna
Insert the tab into
the slot.
the slot.
Main unit (rear view)
Main unit (side view)
Connecting the antenna
cord
cord
Connect the ends of
the antenna cord as
shown above.
When insulation
covers the tips of
the antenna cord,
twist and pull off
the insulation.
covers the tips of
the antenna cord,
twist and pull off
the insulation.
When positioning the antennas, find the best position for reception while listening to an actual radio program
(refer to "Listening to Radio Broadcasts" (
(refer to "Listening to Radio Broadcasts" (
page 19)).
Vinyl-covered wire: 3 - 5 m
(not supplied)
Twist together vinyl-
covered wire and the AM
loop antenna cord.
Stretch out the vinyl-
covered wire horizontally,
preferably in a high place
such as above a window
or outdoors.
Connect the AM loop
antenna cord to the main
unit together with the
vinyl-covered wire.
Main unit (rear view)
UX-QD9[UN].book 11 ページ ２００４年９月２８日 火曜日 午前１０時５４分