JVC UX-EP25 ユーザーズマニュアル
15
Resume Play for MP3/WMA
If you press
7 while playing MP3/WMA, the number
of the track where you have stopped playback will be
memorized by the unit.
By pressing CD
memorized by the unit.
By pressing CD
6 or USB MEMORY 6, you can
start playback again from the beginning of the same
track.
track.
To activate/cancel resume play
Remote
ONLY
ONLY
memo
• Pressing OPEN/CLOSE (for Disc), or
disconnecting the USB mass storage class
device will erase the track number for
resume play.
device will erase the track number for
resume play.
• To play back from the fi rst track while
resume play is activated, press
7 twice
during playback.
Playing Back from the PC
This System is equipped with a USB terminal on
the rear panel. You can connect your PC to this
terminal and enjoy the sound out of your PC.
When you connect your PC for the fi rst time,
follow the procedure below.
• Remember you cannot send any signal or data
the rear panel. You can connect your PC to this
terminal and enjoy the sound out of your PC.
When you connect your PC for the fi rst time,
follow the procedure below.
• Remember you cannot send any signal or data
to your PC from this System.
✎
IMPORTANT
• Always set volume to “VOLUME MIN” when
connecting or disconnecting the other equipment.
.
How to install the USB drivers
1
Turn on your PC and start running Win-
dows
®
98SE, Windows
®
Me, Windows
®
2000, or Windows
®
XP.
• If the PC has been turned on, quit all the ap-
plications running.
2
Select USB AUDIO for the source.
3
Connect the System to the PC using a
USB cable (not supplied).
• Use
“USB series A plug to B plug” cable.
4
The USB drivers are installed automati-
cally.
To play back sounds on the PC
Refer to the manuals supplied with the sound
reproducing application installed in the PC.
reproducing application installed in the PC.
* Microsoft
®
, Windows
®
98SE, Windows
®
Me, Windows
®
2000 and Windows
®
XP
are registered trademarks of Microsoft
corporation.
corporation.
memo
• DO NOT turn off the unit or disconnect the
USB cable while installing the drivers and for
several seconds while your PC is recognizing
the receiver.
several seconds while your PC is recognizing
the receiver.
• Use a full speed USB cable (version 1.1).
Recommended cord length is shorter than
approximately 2 m.
approximately 2 m.
• If your PC does not recognize the unit,
disconnect the USB cable and connect it again.
If it does not work yet, restart Windows.
If it does not work yet, restart Windows.
• The installed drivers can be recognized only
when the USB cable is connected between the
unit and your PC.
unit and your PC.
• The sound may not be played back correctly—
interrupted or degraded—due to your PC
settings and PC specifi cations.
settings and PC specifi cations.
(rear panel)
USB cable
PC
RESUME ON
RESUME OFF
FM
AM
AUX
USB AUDIO