JVC UX-EP25 ユーザーズマニュアル

If you are having a problem with your System, 
check this list for a possible solution before 
calling for service.

 

@ There is a time limit. Repeat the procedure 

@ The built-in microprocessor may malfunction 

due to external electrical interference. Unplug 
the AC power cord and then plug it back in.

@ The path between the remote control and the 

@ Point it at the remote sensor on the font panel.

@ Signals cannot reach the remote sensor.
  More closer to the System.
@ The batteries are exhausted.

@ Speaker connections are incorrect or loose 

@ Headphones are connected (see page 9).
Sound from PC connected with a USB cable has 
some noise. (See    page  15)
@ PC is subjected to excessive load due to using 

@ PC is connected via USB Hub. Connect the PC 

Hard to listen to broadcasts because of noise 
(see pages 4 to 7).

@ Antennas connections are incorrect or loose.

@ The AM loop antenna is too close to the 

@ The FM antenna is not properly extended and 

@ The disc is placed upside down. Place the disc 

@ Track names have the initial letter “.”.
The disc sound is discontinuous.

@ The disc is scratched or dirty.
The disc cover does not open or close.

@ The AC power cord is not plugged in.
The iPod doesn’t playback although the display 
indicates CONNECT.
@ The battery is empty. Let stand for more than 

@ The System has been turned on when the on-

@ There might have been a power failure.
  Set the clock fi rst, then the timer again.